Question about General Washing Machines
Posted by Anonymous on
E3 mean to much water in washer,check inlet valve, are call a techicain to solve your problem
Posted on Jun 24, 2019
an E90 fault is a problem relating to the main control module found behind the front facia. it could just be a bad connection on the board connections though
Posted on Dec 13, 2008
Error code F07 is indicating that the heater relay is stuck for one reason or another.
This could be a board problem, as this where the relay is located.
However, it would be worth checking that the heater is o/k before you do anything else., as this possibly could cause the relay to malfunction.
Plz rate my solution.
Posted on Jan 13, 2009
Looks like you have either a stuck drum (does not spin) or an electrical fault that make the washer think the drum is not moving.
From a 2006 Technical Bulletin:
E3: Machine control is attempting to drive the motor but is not seeing any tach response. Visual Check shows motor is not moving. (Locked or Hall Sensor fault.)
Specifically, it could be:
1. Spin drum stuck – Verify that the spinner moves freely to eliminate this cause.
2. Hall Sensor (integral part of motor) fails or is loose – When the Hall Sensor fails or becomes dislodged, the control doesn't recognize that the motor is spinning and shuts down. The result will likely be an “E3” code in the worst case, or “SUdS” if it is only getting a partial rpm reading. Check wire harness connector(s) to motor.
Unless you are really overloading your machine you likely have an electrical fault, or a failure in the drive train--especially if the problem is intermittent. Probably time to call in a technician.
Posted on Aug 13, 2009
Tips for a great answer:
Jan 06, 2016 | Washing Machines
May 15, 2012 | Washing Machines
Aug 24, 2011 | Maytag Neptune FAV6800AW Top Load Washer
May 24, 2017 | Fisher Washing Machines
134 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: