Whirlpool electric oven

Start here

You will need to replace the control board. Here is the part to order.



The part comes with a 365 day, any part, any reason return policy.

To Set a Cook T ime:
1. On double oven models only, press UPPER OVEN or LOWER
OVEN for the one you want to set.
2. Press BAKE or CONVECT UPPER (on some models).
Press the number pads to enter a temperature other than the
one displayed.
3. Press COOK TIME.
4. Press the HR and MIN "up" or "down" arrow pads to enter
the length of time to cook.
5. Press START/ENTER.
The start time and stop time countdown will appear on the
oven display.
On double oven models only, when both upper and lower
ovens are being used at the same time, touch UPPER OVEN
or LOWER OVEN to display the respective cook time.
When the stop time is reached, the oven will shut off
automatically and "End" will appear on the oven display.
If enabled, end-of-cycle tones will sound, then reminder
tones will sound every minute.
Repeat the process by choosing the other option of UPPER or LOWER OVEN

Hello & Welcome to FixYa

Error code F1 is displayed due to electronic oven control failure and the only way to solve this problem is by replacing the control board which is bad. Sorry for the bad news but hope you understand... Please get back to me if you have any other questions.

Kevin

Do you have a push button in the centre , between 2 dials and under display? If so, try pushing it twice then turn oven dial

Usually this is a touchpad and control panel fault but the only way to know for sure is to do some electrical testing with a volt/ohm meter and the wiring diagram located within the appliance.

With the model number of the oven we could look up the code and be more specific about the problem.


Go here for: http://www.repairclinic.com/Whirlpool-Range-Stove-Oven-Parts

RepairClinic.com


appliance parts, help & more

Good Morning!
An E6-F2 is a very common control board failure. The control board in your appliance will need to be repaired or replaced.

Read more below about common Whirlpool oven Fault codes and what they mean.
GBD RBD Whirlpool Oven Problems Causes and Solutions 8302319 Whirlpool ELECTRONIC OVEN CONTROL CIRCUIT BOARD EOC

Below call the toll free number and ask them why the display stopped working. Let me know also if I can help, Thanks, Sea Breeze

Call the Whirlpool Consumer Assistance
El
Center telephone number.
w
Dial toll-free from anywhere
in the U.S.A.:
I -800-253-l 301

Turn the breaker off that supplies the power to the oven for 5 minutes to allow the computer to reset. If this doesn't work you my have a bad board.

I have a Whirlpool MOD. RBS275PDB17 single electric self-cleaning oven; although the manual is generic, it specifies, "When the cycle is completed and the oven cools, "End" will appear on the lower oven display and "LOCKED' will disappear" and "To Stop Self-Clean any time: Press UPPER/OFF, LOWER/OFF or OFF/CANCEL. If the oven temperature is too high, the door will remain locked. It will not unlock until the oven cools." Has your oven had time to cool?