Question about Sony KP-51HW40 51" Rear Projection Television

1 Answer

Sony KP-51HW40 51 Screen Protector

Where can I find a replacement screen protector?

Posted by thehair on

Ad

1 Answer

crispin melchor

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 231 Answers

This tv has three parts to screen , the most outer part is called CONTRAST screen part # 408195411 for the model you gave.This is available @ sony.com (parts&access) Please make sure this what you need and model is correct..Good luck

Posted on Nov 29, 2007

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

Smartphone how can i replace screen protector without air bubbles like Pro does ?

Before putting the new protector on the screen must be completely clear of any dust/dirt. I use an alcohol wipe first to clean the screen then a clean microfibre cloth to dry the screen and wipe away any remaining small dust particles, then slowly apply the new screen protector like in the video above
0helpful
2answers

Blue lines in screen

Follow the steps below after verifying that the issue is occuring on other channels and other video sources.
  1. Turn off the television. IMPORTANT: For a projection television that uses an internal lamp, wait 5 minutes after turning off the television to allow the lamp to cool before continuing with the following steps.
  2. Unplug the television power cord from the electrical outlet.
  3. Let the television remain without power for 60 seconds.
  4. Plug the power cord back into the electrical outlet. NOTE: If the television is plugged into a power strip or surge protector, remove it from the power strip or surge protector and plug it directly into the wall outlet. If the issue is resolved, the problem is with the power strip or surge protector and not the television.
  5. Turn on the television.
If the issue is still unresolved, service may be required.
1helpful
1answer

Sony wide screen projection tv model kp-57wv600 problem. Sound with no picture. Stanby red light blinks seven times? What parts do I need to repair the problem. Thanks ,Gary

I found this solution from SONY's website.

The STANDBY light will flash if an issue is detected within the television. This can sometimes be resolved by simply following the steps below to reset the television.
  1. Turn off the television. IMPORTANT: For a projection television that uses an internal lamp, wait 5 minutes after turning off the television to allow the lamp to cool before continuing with the following steps.
  2. Unplug the television power cord from the electrical outlet.
  3. Let the television remain without power for 60 seconds.
  4. Plug the power cord back into the electrical outlet. NOTE: If the television is plugged into a power strip or surge protector, remove it from the power strip or surge protector and plug it directly into the wall outlet. If the issue is resolved, the problem is with the power strip or surge protector and not the television.
  5. Turn on the television.
If the issue is still unresolved after following all of the troubleshooting steps, service may be required. Please note the number of times the STANDBY light flashes and relay that information to the service center.


I hope this helps.
0helpful
1answer

Screen protector broken

The protective screen is part # 409088101 and is available from tritronicsinc.com for $103.01

Dan
0helpful
1answer

Sony kp-53hs30

I was checking for one similar.The name is "LNTICULAR"
In Texas you can find a provider
Price $280.00 plus $80.00 S&H more o less.
Let me know to send the address
[email protected]
0helpful
2answers

Cracked Screen Protector

what is the model number for you set. is it a hd52w56 or something like that. on that model it is called the super sheild. is the inner screens damaged.. if just the outer screen that runs 200 or more. i have seen people just replace the plexiglass on it. the inner screens run about 250

0helpful
1answer

Sony Bravia KLV-40U100M-screen is distorted, overlay or various vertical lines

The resolution on this was to check the surge protector the television was plugged into. Once we unplugged and plugged into another surge protector, the screen went back to normal and the appearance was great. We believe this was due to one of the resistors within the surge protector may have become faulty.




0helpful
1answer

Sony KP-65WV700 65

This may be nothing more than dirt, hair or dust on the picture tube magnifier glass ( you can clean this by opening the front and cleaning like you would a window glass) or it may be more serious like a high voltage divider control. I would suggest you try cleaning the tubes first and if it's not that, then seek qualified help. ( PS. Always unplug the set from the wall before working inside the set ).
I hope this has helped.
Happy President Day.
Ed
NC Electronics
Mills, Wyoming
Not finding what you are looking for?
Sony KP-51HW40 51" Rear Projection Television Logo

Related Topics:

204 views

Ask a Question

Usually answered in minutes!

Top Sony Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76823 Answers

Ekse

Level 3 Expert

13435 Answers

Nasir Muhammad
Nasir Muhammad

Level 2 Expert

252 Answers

Are you a Sony Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...