Question about AEG Washing Machines

Open Question

I have an aeg oko lavamat 538cannot wash but spins nicely

Hi,the machine turns on puts water doesn't wash,but the timer moves,it drains n spin dry,the wash cycle doesn't move the drum to wash,pliz help

Posted by on

Ad

5 Suggested Answers

Anonymous

  • 51 Answers

SOURCE: Will not drain or spin

Unless you jarred the machine it's the timer. You can check this by bypassing the lid switch and seeing if it will cycle.

Posted on Dec 13, 2007

Ad

Anonymous

  • 185 Answers

SOURCE: washing machine agitator & drum spin during wash cycle

check the dogs in your agitater

Posted on Mar 25, 2008

Ad

carsija1

  • 1 Answer

SOURCE: aeg 76669 oko lavamat machine not


I have had the same problem. If you switch the machine to off and then to cotton/linen 95, then press at the same time prewash, soaking, qick wash and stain buttons for 10 seconds switch it off. When I switched it on it worked.

Posted on Jun 24, 2008

Mukesh Kumar

  • 3230 Answers

SOURCE: AEG OKO Lavamat Update washing machine LAVALOGIC 1600

Hello,
This error code (C3) means your water sensor has detected a leak. it will stop when the sensor is dry.
Try getting the water out of the trap door and letting the machine dry.

I would also unplug it for secirity reasons.

Basically your water pump is getting tired or the sensor is dirty. Try cleaning the sensor or else you may have to change the pump.

Good Luck!!

Posted on May 06, 2009

YOGENDRAN K

  • 57 Answers

SOURCE: The drum doesn;t turn during wash or spin cycle

Hi,
Kindly remove the back panel of the unit and check whether the belt is properly fixed if it is ok means check the wire connection if everything is fine. kindly check the motor humming sound once the water is filled if you find the humming sound means kindly replace the motor

Posted on May 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Our washing machine is being placed in storage, but we can still hear water in the bottom of the machine (not in the tub). Is this normal? It seems like we should get all the water out before storin


If its a front loader there is liquid inside the drum put there by the manufacturer for balance and stability when the machine is running, that's probably the water sound you hear when you move it around.

Feb 16, 2015 | Kenmore Washing Machines

1 Answer

Hoover optima 614 drum wont spin


Either a broken drive belt or a failed transmission.

Jan 12, 2015 | Hoover Washing Machines

1 Answer

Samsung WF7700N6W1 washing machine not draining


Could be a sock or something between the 2 drums that moves over the outlet hole from the drum when upright and trying to drain but moves away when machine is on its side. Get a flashlight and look through the holes in the inner drum and you may find the culprit.
A coin may also be stuck in by the pump blade, not always easy to see but worth a look.

Dec 22, 2012 | Samsung Washing Machines

1 Answer

Motor sounds like it is turning the drum but drum is not turning


Check your timer. Jiggle the selector knob,then move it to a position just prior to the spin cycle, see if this helps.

Oct 27, 2012 | Bosch Washing Machines

1 Answer

How to move around brandt wm 550


see this causes and fix it. God bless you
When the cycle doesn't advance, it's probably the timer or a cold-water supply problem: It's the timer, if your washing machine fills with water and begins agitating, but the timer never advances--or if the washer is in a spin cycle and the timer won't advance. Then you need to replace the timer. It may be a cold-water supply problem, if the washing machine fills with water, agitates, drains, and spins, but then doesn't fill with rinse water. See There's no cold water.

Sep 22, 2012 | Washing Machines

1 Answer

Doesn't spin


In top load washers, if the machine goes through the cycles and then just stops at the spin cycle and leaves you with no noise and a tub full of water more than likely the lid switch is bad and not completing the circuit for cycle to continue. This is a safety precaution to prevent injury by reaching in the machine while at high speed spin. If the machine is getting to the spin cycle and still turning slowly but not draining the water, the pump is probably the culprit, either being locked up or in most cases something like a sock, etc. is stuck in it preventing it from turning. This is usually indicated by a humming sound during the spin/drain section with no water draining.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/jason_4570d45317834dd3

Apr 29, 2012 | Kenmore Washing Machines

1 Answer

Hi, My Hoover 600MB top loading washing machine is approx 8 years old. Recently it has occassionally not fully spun out - clothes still wet at end of cycle. Now it also often doesn't agitate - just...


Have a look for coins etc stuck in the drain pump or the tub outlet hoses especially where they fit onto the tub. If a coin or other foreign material blocks the water flow when draining , these machines wont spin properly.

Jul 26, 2011 | Hoover Washing Machines

1 Answer

Frigidaire washing machine gets stuck on cycles


The cycle doesn't advance When the cycle doesn't advance, it's probably the timer or a cold-water supply problem:

  • It's the timer, if your washing machine fills with water and begins agitating, but the timer never advances--or if the washer is in a spin cycle and the timer won't advance. Then you need to replace the timer.


  • It may be a cold-water supply problem, if the washing machine fills with water, agitates, drains, and spins, but then doesn't fill with rinse water. See There's no cold water.

Apr 01, 2009 | Frigidaire Washing Machines

2 Answers

WMA54 Hotpoint Aquarius drum does not turn during wash or spin


Start checking the lid switch, if this is stuck the machine wont start.

If the drum does not move at all, the motor, the motor control unit, the motor coupler, the control board may be faulty.

For more details you need to observe if machine is draining and pumping water inside during cycle, see: It doesn't spin


Jan 06, 2009 | Hotpoint WMA54 Front Load Washer

1 Answer

Will not drain or spin


Unless you jarred the machine it's the timer. You can check this by bypassing the lid switch and seeing if it will cycle.

Dec 13, 2007 | Washing Machines

Not finding what you are looking for?
Washing Machines Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top AEG Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers

sami

Level 1 Expert

24 Answers

Vincent G
Vincent G

Level 3 Expert

2361 Answers

Are you an AEG Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...