Phone/handset problem Hello, I brought this phone a few years ago, lately i have been having problems using the handset. When i use the speaker phone the phone dies immediately and i get an error msg if i try to redial the # " no link to base/system" We are having VOIP and i tried resetting the router ( that has phone cables/internet cables) still it does not help. if the phone is not being used for few hours when i try to make a call i get the msg on the display screen " no link to base" Please let me know if it is my battery that needs a replacement or the phone itself? Thanks in advance,A

SOURCE: Handset No Link To Base error and no dial tone

I have the problem. I think it is because the battery i have in it was a Ni-MH and it should be a Ni-Cd. I am now looking for the right baterry Good luck Frank [email protected]

Posted on Sep 17, 2007

SOURCE: handset has No link to base

I was having the same problem with the same model phone, and fixed the problem by rebooting the phone – unplugging the AC and phone cord from the base station and plugging both back it, then removing and replacing the handset to regenerate the security code.

Posted on Nov 19, 2007

SOURCE: Handset ?No Link To Base? error and no dial tone

2/29 Have you registered or re-registered the handset?
"No link" can mean handset is not accepting radio wave of base unit. At Mfgr website pull-down operator's manual and look for registration instructions. Some sequence of buttons will create a radio signal from base (have handset off base) then another sequence of buttons on handset will accept radio signal. If handset has "menu" button, try "menu", then "00" (zero zero) then select an accept or "OK" button. Good luck.

Posted on Feb 29, 2008

SOURCE: GE 900mhz model 26936GE2-C

HI NEED HELP MY PHONE IS SAY NO LINK TO BASE

Posted on Jul 03, 2008

SOURCE: i have problems the no link to base with Panasonic

• Press and hold the LOCATOR/INTERCOM button for the extension that is displaying "No Link To Base" on the Base until a beep sounds.
• Press and hold the FLASH/CALL WAIT button on the Handset that is displaying "No Link To Base" until a beep is heard.
• When registration is complete, a beep sounds from the handset.
• Wait for 20 seconds after registration is complete to allow the handset to establish communications with the base.

Posted on Jul 08, 2009