Lexmark printer 3500/4500

SOURCE: 3500-4500 series lexmark printers

You should be able to download a new set of drivers from Lexmark's website.

Posted on Jun 09, 2008

SOURCE: LEXMARK 3500 4500

1. Turn the printer off and open the access cover.
2. Look for any obstructions in the paper path and remove them if necessary. (It is possible to move the carrier assembly with the power off.)
3. Turn the printer on, load some paper, and press the Form Feed button. (On the X83, press the Select button.)
4. Watch the paper as it feeds through and try to determine where the jam is occurring.
5. Check to see if all the rollers are turning.
   
   If all the rollers are turning, there may be something in the feed path that you can't see. Go to step 6.
   If not, there is probably a feed motor or a gear problem and the printer may require service.
   
6. If the paper is jamming under the carrier assembly, you may be able to fix it using the manual feed slot.
7. Turn the printer off.
8. Take a #10 envelope and feed it through the left side of the manual feed slot until it comes right through the printer to the back of the exit rollers.
9. Move it up and down first, and then slowly move it over to the right side. If something is stuck under the black guide plate, this may work it loose.

Posted on Jun 16, 2008

SOURCE: lexmark printers 3500-4500

did you get a new fresh set of drivers?

www.lexmark.com

Posted on Jun 24, 2008

SOURCE: how to install lexmark 3500=4500 series printer without setup disk

To all Lexmark owners with the lost disk problem.

If you do not have the disk you must download the software from Internet, follow instructions below,

Click here:Official Lexmark Drivers and Software

A web page will open, follow instructions, select model, select operative system etc., and click on download .
Chose to download the file in my documents when asked.
After downloading, find the file,double click on the file ,then if you get in troubles, follow the instructions below to reset and reinstall drivers:

• Unplug printer USB.
• Go to control panel >> installed printers in Windows and remove (delete ) any installed printer from printer list.
• Download driver from website, or use the disk and run the install file.
  
• Follow driver installation wizard.
• Plug back printer when prompted from installation wizard.

If you instead want to purchase a new disk, bear in mind that Lexmark does not distribute replacement install disk for all models.

Contact Lexmark here, to see if the disk for your printer is available.


Note:some printerdoes not work on Vista, if you do not find any driver download for Vista on your model page, that means your model is not Vista compatible.

Posted on Apr 07, 2009