Question about Pioneer PRO-700HD 64" Rear Projection Television
Okay. My T.V. has a problem. It's problem is when I turn it on, the t.v. will stay on for 2-3mins then it will go black with a lite lite picture of what you where watching. Meaning you can barely, I mean barely see what is going on on the t.v. when watching something. I just can not figure out what is causing it to go black like that. If you can please send any response to this or info that you or someone may have. I thank you so much.
SOURCE: Pioneer PRO-710HD 64 in. Rear Projection
Bad solder joints on CRT power supply board.
Posted on Oct 09, 2007
SOURCE: PRO-510HDTV
The intermittencies you mention are common on this
series. The PS - power supply - board needs a
virtually complete resolder op, as the solder used in
that run of units was weak and thin. It will not get
better on its own, any more than needed dental work
will.
Send it to me and I will resolder it and send it back.
I have done so on a number of PS boards in this series,
and am running at 100% success on saving the
510/610/710 series of Pioneer Elites when all they need
is the resoldering op. There is a procedure to follow,
so contact me directly.
www.imageperfection.com
510-278-4247
Mr Bob
Posted on Feb 07, 2008
SOURCE: pioneer elite pro 118
if the tv is more than 10 years old no its not worth replacing the power supply.if its 5 years or newer yes it owuld be worth the money
Posted on Sep 07, 2008
SOURCE: just got a pioneer elite pro 119 from a buddy of
If you don't mind opening the thing, open it up and follow the power lead inside the TV. Somewhere along the line should be a fuse. I'd start there.
Posted on Oct 06, 2009
SOURCE: pioneer elite pro-530hd tv---no picture at all!
I have a 532nd 53 that shuts off and red stand by lite comes on in the back. If you wait awhile and unplug it and plug it back in it will come on again and then shut off after an hour or two
Posted on Oct 26, 2009
201 views
Usually answered in minutes!
×