Het3 elite After end of all cycles tub occasionally starts to refill with water. Door open or closed seems to make no difference. Sometimes hitting drain and rinse cycle stops the problem sometimes the tub begins to fill again immediately. Water is filling from bottom of tub.

Its not dryer only washer the proplem in dryer only

Has the dispenser door open at end of cycle. If dispenser door is open but not fallen down to the tub means most likely the water arm pressure is not good enough to get flush down to the tub.

Door not open means dispenser failure or control board not giving power to dispenser at right time. In some cases dispenser door is stuck with harden earlier soap so it cannot open completely in the cycle.

Why not when opening the door at end of cycle, listen to dispenser area to see the flapper opening while you are opening the door. That means dispenser not opening properly in the cycle.

This issue is a hard solve sometimes. Don't wont to spend the money, then just use the tablets and through them in the tub in the beginning and say good bye to dispenser.

The main switch, which is driven by its own motor, needs replaced.
murf427

To clear the cycle open the door and press cancel, close the door and it will cancel.

Below is a link to the manual.


Link:

that is correct ,. pump water out then the door will open.

Remove the filter from the lower front section of the wash tub and clean it out.
Then start a wash cycle with no dishes and no soap.
Once the water fills and starts washing,open the door and pour 1 quart of white vinegar in the wash tub.
Close the door to resume the wash cycle.
Let the machine run a complete cycle to the end to help clean out the water ports.

They start with hot or warm ,what/ever the setting and rinse with cold water. Check the temperature adjustment and the cycle it's on as some do different things on different cycles.

Sounds like the motor is stuck. If your careful you can unplug the dishwasher or turn the breaker off, take the bottom panel off and reach in with your finger and spin the motor assembly.

door switch not close properly when cloth hit door .
door switch open .tight door hinges or sticky pad tape
on door wher door switch pressed

sounds like a bad water inlet valve stuck open and permitting watertto enter even though not on, untill you replace the valve turn off water between uses part number 8181694