Monogram Dual range keeps clicking when turned on

Hi,

Here is a tip that I wrote that will help figure out why the burner spark keeps on clicking...

Gas Range Repair Burners Keep on Clicking

heatman101

First I would replace both front igniters thier about $20 a piece this should fix the clicking. They keep clicking because they are not sensing the flame. The front burner assemblys will need to be thoroughly cleaned. There are very small orfice holes that need to be spotless. Also the burner cover, the top piece that pulls off. Make sure the bottom lip is very clean. Use a fine wire like a paperclip to clean out the holes in the burner assembly. For diagrams or illustrations enter your model # at www.appliancehelponline.com

Hi,
Here is a tip that I wrote that will help figure out why the burner spark keepson clicking...

Gas Range RepairBurners Keep on Clicking
heatman101
w3

turn breaker off and on control may reset and work if not
you need control witch is not available
option 1 we can do upgrade to covert control to newer dacor system
cost is around $1400 can if you are in our service area
option 2 other than that you can have control sent out for rebuild they can not always repair
option 3 call dacor they may offer you a discount on new range as parts are no longer available
good luck hope breaker reset works

just remove it from the board .
and please be carefull

.FRANKIE.

Check the position of the ignitor that sparks, compare it to the burners that do lite.

The other one may ne replacement

We love ours have had it for two years. We have the 48" Dual fuel with the grill on top. Model ZDP48N6RH2SS.

The only issue we had to adjust to is the btu's (stove top flame) are so high and there is designated simmer burner or low btu burner.

The grill is excellent especially in the winter but you have to follow the instructions. First time use we didn't let it heat up long enough. Patience - it's worth it.
That's for our model from 2006.
YOu must be sure to get a strong enough range hood for the range you buy.

I had the same issue with washing the top with water and cleaning solution. I had arching, eventually one burner failed to ignite. I tried the above solution and it did not work. Remove the ceramic top on the burner that will not ignite. Turn on another working element. Do you see the igniter working?

If so slowly turn on the gas on the failed burner and it will ignite. I'm looking into what component automatically controls the igniting and gas release when the knob is turned on.

replace the electrode that's the wire or pilot tip, it has a sensor built in, when it gets hot it stops automatically. if the electrode is between the front and rear burners, there are small holes on the burners going down on the side of the burner facing the ignition. they need to be clean. try a paper clip and insert the clip in side the holes.

It's the motherboard. You must have had a power surge. I just replaced mine. Motherboard + shipping 200.00. its not easy to replace but not so difficult.