SOURCE: COULD YOU TELL ME HOW
http://www.theretailerscatalog.com/howto.asp has a link to a video clip on how to do this.
I know that sometimes that written steps and documentation, though helpful to some, is not as helpful where video can step in. Towards the top of the page, there is a video link, click that. Then click on the 1130 link and you should have what you need.
SOURCE: Sato 408E problem
Using direct thermal labels it can dirt the printhead and platen roller, you must clean them with isopropyl alcohol and a flannel. Also adjust the darkness to less value to best print.
Roberto Martinez
SOURCE: Monarch 9825 Thermal Label Printer: my monarch 115 pricing gun, the numbers reels gett...
You may wish to have Avery Dennison, the folks that purchased Monarch/Paxar, to service your printer.
Their phone number is 1-800-543-6650 and ask them the correct address for service. Your bands may be getting too loose, and need to be replaced. If it is something that they can instruct you to take care of, they can sell you the bands and provide instruction.
SOURCE: how do i replace the
To replace the ink cartridge,
turn the latch on the right side of the gun to an upright position.
Pull the door out. The ink roller is on the end of the door in a plastic
holder. Push the holder apart slightly to remove the old ink roller and
insert a new one. Replace the door and turn the latch to hold it in
place.
SOURCE: how do I load labels in monarch 1100 price gun
Loading
Insert a roll of labels into the gun opening so
that the beginning of the roll is at the back and comes up over the top
of the gun. Insert the beginning of the roll into the slot, squeezing
the trigger halfway. Push the labels through the gun until they come out
at the front. Thread the labels up and under the black plate on the
front of the gun and then under the rubber roller. Squeeze the trigger
again and pull six or seven labels out. Discard the labels, leaving the
paper backing. Thread the paper backing into the underside of the gun,
next to the handle, in the direction indicated by the arrow. Push the
paper backing while squeezing the trigger until the gun begins
dispensing labels.
Printing
To replace the ink
cartridge, turn the latch on the right side of the gun to an upright
position. Pull the door out. The ink roller is on the end of the door in
a plastic holder. Push the holder apart slightly to remove the old ink
roller and insert a new one. Replace the door and turn the latch to hold
it in place.
123 views
Usually answered in minutes!
×