My rescaling light has not gone off after descaling and it won't work

Pled do cleaning well and descale if this didn't work you have to cheak seals and the boiler but rescaling may resolve your problem

https://www.philips.co.za/c-f/XC000004129/i-cannot-finish-the-descaling-procedure-of-my-saeco-exprelia

https://www.philips.ca/c-f/XC000005641/i-cannot-finish-descaling-my-saeco-xsmall-espresso-machine

It's time to descale your brewer. Run a full reservoir of pure white vinegar through, and then a full reservoir of water, "brewing" and dumping one cup at a time. You might have to do two reservoirs of vinegar if you've never rescaled it before.

Desacle now or it won't reset to factory settings.

I have the same problem with my Delonghi Magnifica, so maybe there is a glitch in the machine..

Hold the hot water button to the right hand side of the brewing group for 8 seconds

The light stays on if you do not follow the instructions when descaling. You must hold the button for 3 seconds to descale. It takes about 20 minutes. If you press the button for less than 3 seconds with the service disc you just run the water through quickly to rinse/clean and the machine doesn't reset the rescale light.

Please read this if your red descaling light won't turn off: Key is to follow directions. When you fill the tank with water to descale add 500 cc - no more. The machine "knows" that the cycle ends when water runs out. Once water runs out the red light will turn off. Continue with cleaning the tank and running a cleaning cycle. The red light is gone and you are good to go.

Hi
You have finished the descale process and your descale light should be gone. Put a fresh tank of water on the machine and then open the steam knob. This should clear the water light and your machine will start heating again.