Question about Rowenta Irons
Posted by Anonymous on
SOURCE: I have lost my operating
Check out a video manual on Conair Fabric Steamer
Click on Appliances category. The video instructions are for GS4 model but it must be similar.
Hope that helps
Posted on Sep 06, 2008
SOURCE: conair compact garment steamer
Push down and twist all the way- I had to watch it done on this website to figure it out!
Posted on Oct 09, 2008
SOURCE: rowenta commercial steamer
got this off the manual for the IS 7800
Remove water container and clean the main unit with a damp
cloth. To maintain maximum performance, your steamer must
be descaled occasionally. The descaling intervals will depend
on the water quality and the frequency of use. The unit should
be descaled at least once a year or every 100 hours of use.
For descaling proceed as follows:
1. Unplug the unit and remove water container from main unit
by releasing container lock and pulling up.
2. Fill it with fresh water and shake vigorously to remove any
scale. Pour out the water and repeat if necessary.
3. Purchase a quality decalcifier agent and follow the instructions
of the manufacturer for the proper ratio of the mixture
to water and use.
4. After filling the water container turn it up and down to
5. Attach reservoir to unit, plug in and switch on.
6. Let the appliance run until the water container is almost
empty and do not steam any clothing with this mixture.
7. Unplug and detach the water container. Rinse it with fresh
8. Fill water container with fresh water and repeat steps 5 and 6.
Note: If after descaling you believe that there is still buildup in
the boiler, repeat steps 1-8.
Posted on Oct 31, 2008
Ok. This thing is caused by scaling. If the steam generator runs out of water the sensor thinks the tank is empty and causes the machine to go to standby (basically switch off -- orange light comes on). The solution: Open the machine and clean it.
MAKE SURE THE POWER CABLE IS UNPLUGGED BEFORE ATTEMPTING TO DO THE FOLLOWING:
1. There are six screws ( phillips - you will need a long screwdriver). Two of them are hidden under the wheels (just pop off the rollers and you will see the screws)
2. Open the steam generator (there are four screws) and be very careful with the 'O' ring -- you damage it and you can say good bye to the machine. Clean it if you see scaling. The amount of scaling present would indicate how hard your water was. This itself may not be cause of the problem but now that you openend the machine, you might as well as clean it for better efficiency.
3. Disconnect the hose to the steam generator (it has two circlips) and clean it. Mine had hard deposit of scales preventing the water reaching the steam generator.
Re assemble it.
Posted on Apr 10, 2009
To start with, use distilled water for steaming. This will prevent calcium build-up. I buy bottles of distilled water for ironing/steaming only. I have never had calcium build-up from using distilled water for ironing/steaming. Do not use tap water!!!
You can buy some CLR (stands for Cacium, Lime & Rust) (can be found at Walgreens, CVS, Target, Walmart, etc.). You can run this product through your steamer to eliminate build-up.
Posted on May 19, 2009
Tips for a great answer:
Aug 26, 2015 | Rowenta IS9100 1550W Precision Valet...
Sep 08, 2014 | Rowenta Commercial Garment Steamer - White
Aug 13, 2014 | Rowenta Commercial Garment Steamer - White
Jul 08, 2014 | Rowenta Commercial Garment Steamer - White
Dec 26, 2012 | Rowenta Commercial Garment Steamer - White
Sep 03, 2008 | Conair Compact Garment Steamer Iron
157 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: