I need a password for a plantronics sgh-a767 to

1. Tap Menu > Settings > Bluetooth > Search.
2. The available devices will display.3. Tap to select the desired device.4. Tap Pair to pair the device.5. Enter password > OK. (should be 0000)

For all current Bluetooth headsets the passkey is 0000 (four zeros).
If the phone does not accept this code, please refer to your cell phone user's guide to ensure the proper setup procedure.

Note: Powering your cell phone off and on sometimes corrects this issue. You cannot change or personalize the PIN code/password of the Bluetooth headsets. It will always remain four zeros.
There is a link below to the Plantronics 320 User's Guide which may help you also.
Plantronics 320 User's Guide


Good luck from Headsets Direct!

Take a look at the following to help pair the Plantronics 220 to a Bluetooth cell phone:

How to Pair the Plantronics Explorer 220 Bluetooth Headset

Good Luck from Headsets Direct!

To pair your Plantronics Explorer 230, click on the following and should only take a few minutes with detailed instructions and picture:

How to Pair your Plantronics Explorer 230 Headset

Good Luck from Headsets Direct!

Most blue tooth manufactures use a 4 digit pin or pairing code they are as follows 0000,1234,1111,or 9999 i hope this helps

Hi,
1.First switch on the bluetooth in mobile phone.Keep the headset switched off.
2.Now press the call button for 2 seconds if you are paring this headset for first time,If this head set is aired already with another mobile press for 8 seconds until the headset status indicator begins to flash blue then red
3.Now search the bluetooth by your mobile device.It detects and you can pair it
Thank You

try 1234 or 0000

Hold down the call button on the headset and wait for it to flash slowly blue. Make sure your phone is in "discoverable" mode. You should see your phone asking to connect to the plantronics headset. When it asks for a code, enter 0000.

I have samsung sgh-a707 phone cannot pair my new plantronics 521blue tooth.I search but get "no devices found".is it the phone or bluetooth?Help

Begin with headset turned off.
1. Press call control button for
6 seconds. Release button when
indicator light flashes blue and
red. Headset is ready to pair with
Bluetooth device.
NOTE The headset can pair to
multiple Bluetooth devices, but
will only connect to one device
at a time. The headset will automatically
connect to the last
device to which it was connected.
2. While the headset is flashing red
and blue, use the phone menu
to search for Bluetooth devices
and select “3XXPlantronics”.
3. When prompted for passkey enter
0000. Headset will flash blue when
paired successfully.