Question about Hoover Washing Machines
I am a recently retired appliance engineer of 20 years start with checking the other solenoid, the conditioner one, it may be that that is not working, and double check the cold one, remove the two wires and check for a circuit, it may be actually filing up initially with hot water without realising it, always work with safety remove the plug before removing panels etc if i have helped rate me please
Posted on Sep 09, 2007
i would check the motor carbons it could be your problem if it fills goes through the programme until the end but has motor action
Posted on Apr 12, 2010
Hello,The motor mounting are usually the tensional method for the drum belt. You need a socket set to take the motor off and replace.Don't over tension the belt as it will ruin the bearings in the drum and motor.You should be able to deflect the belt by half an inch in the middle of its longest run with medium thumb pressure.Watch out for sharp edges on the cabinet when heaving on a bolt.
Posted on May 23, 2010
SOURCE: How can I obtain any
A manual above.
Also by contacting Hoover washing machines direct and asking for a copy of the manual. link below.
Posted on Nov 09, 2010
Tips for a great answer:
Dec 17, 2011 | Hoover Washing Machines
Jun 06, 2011 | Washing Machines
Feb 09, 2011 | Hoover Washing Machines
Apr 26, 2010 | Washing Machines
Apr 13, 2010 | Washing Machines
May 02, 2009 | Washing Machines
Sep 21, 2008 | Hoover Washing Machines
409 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: