The. Probe is not working on our Oneida digital probe thermometer.Can I buy a replacement one? Thank Eileen

FIXYA IS NOT A RETIL OUTLET NOR DO WE KNOW WHO SELLS THEM

Hi Carolyn,
press the refrigerator key and freezer key together for 5 seconds. It should toggle between them.

The best information I could find was that the absolute maximum is 392 F (200 C). Exceeding this temperature will likely ruin the temperature probe.

The buttons should tell you what to do, they are all made be same people just take a few minutes to play with it. Normally set temp you want, or set time you want, pretty easy

Temperature Probe is open. Replace probe.

not normal
problem thermostat not lighting the gas or turning the gas off to maintain an even temp
temp variation should be around a 10 degree range
call a gas fitter to check out the oven controls , thermostat or thermocouple

Hi.

1 Consider that most digital thermometers take a temperature in less than 30 seconds, quickening the temperature-taking process for squirmy children.

2 Read the thermometer's instructions carefully. Never throw the instructions away. Keep them near your digital thermometer.

3 Wipe the thermometer probe with a soapy washcloth or a tissue dabbed in isopropyl alcohol or put on a clean probe, depending on your brand of thermometer.

4 Turn the thermometer on.

5 Use a gentle rocking motion as you insert the thermometer into the ear canal or rectum. Never push or cram the probe into the body. Forcing it causes pain, especially if there is swelling in the ear canal or rectum.

6 Listen for the beep.

7 Remove the thermometer.

8 Read the thermometer. If you see "ERR," you did not get good contact with the ear canal or rectum, and will need to take the temperature again.

9 Use the chart insert that comes with your thermometer to see what your normal reading should be.

10 Clean your thermometer probe with a soapy washcloth and/or isopropyl alcohol before storing.

I left mine in a hot tub for well over an hour. It started reading room temp at about 125 degrees. It worked for me to put the thermometer in the freezer until the readings were correct. hope this works for you.

I have the same problem. The problem is the probe went bad. I had a friend with another sumbeam digital probe (the mavrick) put that probe into mine and the temperature reading was working properly. So, now I am looking for a replacement probe. but looks like I will have to just buy another digital meat probe.