Question about Honda Boating

1 Answer

My 130 Honda over revved for a second before I could shut it down. Now it won't start. Sometimes sputters, but won't catch. Was told might have tripped a protective device. Suggestions.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Honda Master
  • 5,488 Answers

Http://www.marineengine.com/boat-forum/showthread.php?399176-BF-HONDA-130-Won-t-start Here is a forum that talks about it. Hopefully the valves did not get bent.

Posted on Mar 20, 2019

Ad

5 Suggested Answers

Anonymous

  • 1392 Answers

SOURCE: car brake lights won t turn off when car is shut down 1996 Honda Odyssey

It should be your brake light switch. There is a little plate welded to the arm of the pedal that has a hole with a rubber stopper. The rubber stopper is most likely missing, or damaged. You should be able to take a flashlight and see the plate and the switch. If the hole is plugged up, you will need the brake light switch, if not, replace the plug.

Posted on Jun 02, 2009

Ad

Anonymous

  • 5 Answers

SOURCE: 04 ROADKING OVER REVVED AND SHUT DOWN, WON'T

I guess before I can really help you here I need to know if this is a stock bike or not. If it is a stock bike the rev limiter shut the bike down the spark to protect the engine. I find it hard to believe the bike wont start. The bike usaully runs fine again once the engine fall back into the limits of RPMS. Anyhow you might want to disconnect the batterry leads strarting with the negative first and then the psoitive and let it be disconnected for about 15 minutes. This will reset the computer unit in the bike and hopefully start communicationg with the rev limiter again. If the bike still does not start you have more problems then this.

Posted on Jun 24, 2009

deme-tri

joey temal

  • 90 Answers

SOURCE: I have added oil to the enginn as directed on my

clean out the cabrateor
clean out the tank

Posted on Aug 02, 2009

deme-tri

joey temal

  • 90 Answers

SOURCE: New NorthStar generator with Honda GX620 runs only a few seconds.

caborator needs cleaning

Posted on Aug 02, 2009

Anonymous

  • 1 Answer

SOURCE: Kia Rio died in traffic. Will not start.

Hello Kia Owner,
Regarding the shut down, when was the last time you changed the timing belt?? Did you know that the twin cam 1.5 lirte motor needs a new belt every 50,000 miles or 80,000 kms.
If the belt has failed it may still be in tact but with the cogs ripped off.
Your valves have collided with at least one piston but it is good you were only idling at the time.
The motor may be worth fixing. I just fixed mine myself. I had to lift the engine after removing the axles. I removed the old timing belt and removed and rebuilt the cylinder head(big job). Two exhaust valves were boken right off and lying inside one cylinder.
Most likely your timing belt failed as well.

Posted on Apr 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I just bought a 93 Honda Accord and it started over heating and died. I let it sit for the night and went to start it and it won’t start. If it does it’s only for a second and it putters like it’s out of...


Overheating can cause the head gasket to fail and this can lead to coolant in the cylinders. You can then get the sputtering symptom that you are talking about. The problem requires major mechanical work and is not a low cost venture.

Jul 15, 2018 | Honda Cars & Trucks

1 Answer

When I start my 1996 Honda accord the engine seems to sputter rpm gauge revs up on its own and spits and sputters as I'm driving down the road


My sputtering & stalling 1993 Honda Accord - YouTube

? 2:12
https://www.youtube.com/watch?v=Ki2H9aq8Xis
Jun 23, 2011 - Uploaded by mdpbfly
My sputtering & stalling 1993 Honda Accord ... 1996 Acura Integra, hesitation accelerating & misfire. ... 1993 Honda Accord Start Up and Review 2.2 L 4-Cylinder ... SIR B16A Engine sputter/ power loss at higher RPM - Duration: 1:14. by ... 1994 Honda Civic Check Engine Light Code Retrieval Tutorial ...

All comments on How To Solve Honda Idle Problems ...

https://www.youtube.com/all_comments?v=L788jKEVblY
What should I do if once I turn on my Ac my idle drops as if it's gonna die, and .... to a complete stop the rpms start going up and the car accelerates on its own. ... Honda Accord LX, and my Honda just started sputtering in idle. check engine .... My cousin replaced my radiator on my 90 civic and since then my temp gauge is ...

Acceleration Bog/Sputter/Hesitation - Honda-Tech

honda-tech.com/honda-accord.../acceleration-bog-sputter-hesitation-279...
Jun 11, 2010 - 1990 Honda Accord Ex F22 209000 miles, recent alternator change When I ... When I take off from a stoplight I get a little hesitation/bogging/sputteringfeeling until about 2,000 RPM then ... My 1999 Accord had a similar problem (F18B2engine). ... It only lasted a second or so before it would actually rev up.


Dec 28, 2015 | Honda Cars & Trucks

1 Answer

2004 pt cruiser won't start sometimes after you


Good chance fuel pump is getting hot and has to cool down before pumping back up to required pressure. I had to test fuel pressure when cool, then when hot to catch drop in pressure. Are you having any problems with how far you can drive before it quits, or starts to get sluggish?

Dec 05, 2012 | Cars & Trucks

1 Answer

My 1994 Honda civic dx idles rough and sputters like its going to stall . but it runs fine at an increased RPM. when at a stop it acts like it is going to stall ... i was told it was the map-sensor.whitch...


Check your throttle plate and housing, as it could have buildup preventing a stable idle. Can be easily cleaned with an aerosol throttle cleaner with engine off, then starting and moderately revving the engine until it clears out the remains of the cleaner.

Aug 26, 2011 | Honda Civic Cars & Trucks

1 Answer

I've got an '82 YAMAHA SECA 650, and its been frustrating getting it started in the mornings. Over the summer it would start usually, but colder or rainier mornings like the last month (Sept- north of...


Sorry this was never answered.

XJs are cold blooded bikes. Starter fluid usually works. But you may want to check the enrichment circuits on your carburetors. They can get clogged and cause harder-than-usual starting.

Sep 26, 2010 | 1988 Yamaha FZR 250

1 Answer

Honda Tiller revs and works for 30 seconds and then shuts down.


Hello. you have some gunk in the carburator. Get a can of starter fluid or carburator cleaner aerosol and a helper. Remove the air filter and start it up. Spray a little starter fluid into the air cleaner to keep it running for three or four minutes and the problem should clear. If it does not clear the carburator will have to be disassembled, cleaned and rebuilt. j.

Jun 16, 2010 | Honda 25cc 4-cycle Mini Tiller

1 Answer

3 year old Beckett AFG with Clean-Cut system. New inline filter new strainer, new nozzle, flame looks correct in pattern always. Flame does not sputter prior to shut-off. I did notice that when it shut off...


Called Beckett at 1-800-OIL-BURN and explained the problem. They told me that the solenoid on the oil pump (Clean Cut) was the cause. I purchased a new pump for $50 at the local plumbing supply and installed it. Problem solved.

Nov 20, 2008 | Heating & Cooling

Not finding what you are looking for?
Boating Logo

Related Topics:

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Boating Experts

Andrew Taylor
Andrew Taylor

Level 3 Expert

30994 Answers

ray gallant

Level 3 Expert

66568 Answers

Kardoc

Level 3 Expert

5488 Answers

Are you a Honda Boating Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...