Jest bough a elite9ti total scan chirp sonar can I put the transducer at the bottom of trolling motor. And will it work right.

SOURCE: motor won't run

Look at the red indicator arrow when you hit the foot pedal. If it lights up, the motor should run. If not, inspect the splices under the top cover on the shaft. They will stop the motor if corroded or burnt.

Posted on Nov 28, 2008

Dean

• 285 Answers

SOURCE: Mounting a sonor/transducer on a MinnKota Riptide ST

Did the unit come with a strap to mount the transducer to a bow mount electric? Most units do... If not there is probably one available for the unit as an aftermarket accessory or accessory from the manufacturer... Regarding the transducer wire, just wrap and rout this up the front of the bow mount motor shaft so when you pull the motor up and secure it, it is not going to get in the way. You could cable tie the cord down near the bottom of the shaft and one up near the top where they wont interfere with the motor bracket when the motor is positioned up on the boat.

Posted on Mar 17, 2009

SOURCE: transducer is mounted on a

Are you utilizing another unit in your dash? If so, sometimes when both units are on and in sonar mode, their frequencies will intefere with each other causing the vertical lines. I would suggest turning your dash unit off or lowering it's Hertz rate from 200Hz down to 50Hz.

Funny story...I saw this same issue on my boat years ago. I had an X102C up fron and an LCX-19c in the dash. I acutally thought it was some sort of man-made structure and spent time fishing it...DOH!

Posted on Mar 25, 2009

SOURCE: transducer does not work

For 29.95 Ill tell you

Posted on May 13, 2009

SOURCE: my 570 transducer is mounted on trolling motor.

I too have the exact same problem. .6 to 6ft then stays at .6. love to figure this out.

Posted on May 08, 2010