Question about Jura Capresso Coffee Makers & Espresso Machines
SOURCE: printer dfx8500
The DFX-8500 uses a series of beeps to identify errors and error 6 relates to carriage load measurement. This error causes an auto power off after 12 seconds.
Parts that can effect this error are:
PW Sensor - defective
CR Motor - Defective
CR Encoder sensor - defective
Hope this helps
Posted on Jul 16, 2008
Hello, I had the same problem, therefore the machine has gone to a repair centre. The problem is caused by a mechanical switch in the machine, that doesn't work properly. To repair it you've to open the machine completely, but that’s not easy. Because there is nothing broken you’ll should have warranty because it is a production failure. The solution in my case was to heat up the switch and push it a little together so that the contact works properly. It is the switch that you hear when you turn on the machine.
Posted on Oct 30, 2008
SOURCE: No steam on Capresso Impressa S8
Most likely problem is over temp cut out switch. Small diode attached to the boiler to prevent damage during boil dry, or fault in the heating element itself. Difficult machines to repair and best handled by a service technician.
Posted on Sep 14, 2009
Tips for a great answer:
Aug 29, 2014 | Jura Impressa X9 Espresso Machine
Mar 30, 2014 | Jura Impressa X9 Espresso Machine
Dec 22, 2013 | Jura Impressa X9 Espresso Machine
Nov 23, 2013 | Jura Impressa X9 Espresso Machine
Nov 06, 2013 | Jura Impressa X9 Espresso Machine
Oct 14, 2013 | Coffee Makers & Espresso Machines
Oct 02, 2013 | Jura Capresso Impressa X7 Espresso Machine
89 people viewed this question
Usually answered in minutes!
Level 3 Expert
Level 1 Expert
Level 3 Expert