Question about Crafts & Hobbies
Old model glue that used to melt the plastic together isnt avail now what can i do
Buy a cheap plastic welder
Posted on Feb 25, 2019
contact these guys for replacement parts; http://www.gracobaby.com/store/order/default.asp?N=10418+10413+10421&Ne=11 Hope this helps :)
Posted on Jul 27, 2007
SOURCE: harman kardon soundsticks II
use a clear silicone based sealant (similar to the type used for caulking and in fish tanks) I'm guessing you used CA or superglue, and thats what melted your plastic, you're using too much also most likely.
Posted on Sep 25, 2007
yes the evap fan in the frezer should be running when the compressor is running[it may not for a minute or so as it starts up.Amana's are good for the connectors at the evap fan motor comming apart.the connectors are white and will look like its together but when you pull it will come apart.i would always cut the connector out and use a wire nut so wont happen again.if any other questions please email thru FixYa and i will be glad to help. God bless ,tom
Posted on Jan 30, 2009
The disc carrier you're looking for is Part No 7002058 (the number may be stamped somewhere on the holder itself). It's like a circular/figure 8 kinda looking thing on a shaft. If you're in Australia I'll be able to help get spares.
Don't recommend using glue to repair due to stress breaking it again, and for food safety issues.
Posted on Mar 30, 2009
Tips for a great answer:
Mar 24, 2016 | 2005 Nissan Pathfinder
Jul 22, 2014 | Vehicle Parts & Accessories
Feb 15, 2014 | Bolt. Air distributor. Engine air cooling....
Mar 10, 2012 | Computers & Internet
Dec 02, 2011 | Cars & Trucks
Jul 08, 2011 | 2004 Ford Escape
Dec 27, 2009 | 2005 Ford Expedition
Oct 09, 2009 | Mercedes-Benz E350 Cars & Trucks
Jan 14, 2009 | 1998 Dodge Ram
199 people viewed this question
Usually answered in minutes!