Question about Freezers
The mfg is required to put that info on the model & seril plate, at least for all usa appliances. If its an import i guess anything goes, no rules. Try googel the mfg snd model number
Posted on May 20, 2019
The evaporator coil behind the cover on the back
wall inside the freezer will ice up under normal conditions. Every 8 to 10
hours for around 20 minutes the defrost timer (or in most newer models the electronic
adaptive defrost control) will turn the defrost heater on to
melt the built up ice. There is a defrost thermostat which prevents the heater from
overheating the freezer by breaking the heater circuit when the temp reaches
close to 32 degrees F. The entire cooling system shuts off during the defrost
cycle and starts back when the timer advances through the cycle.
If this ice is not melted it will continue to build up until the air can’t flow over the coil to circulate the cold air through the freezer and into the fridge. The temperature change in the fridge is usually noticed first followed by the freezer.
If the defrost thermostat is bad it can prevent the heater from coming on OR it won’t turn the heater off when it gets too warm. It is clamped to the evaporator coil at the top to sense the temp. If it appears to be misshapen it is bad.
With an ohm meter it should show continuity when cold and none when warm.
You can also bypass the thermostat to see if the heater comes on then. If it does then you know the thermostat is bad and needs replaced.
The defrost heater is located on the evaporator. It is in a tube which is at the bottom and can also go up the sides of the evaporator. On some types you can see a burnt spot if it’s bad. With an ohm meter it should show continuity from end to end when disconnected from the wiring in the freezer. You can also test the wiring for voltage when it’s in the defrost mode.
If you have a defrost timer you can test it. It can be located under the fridge behind the kick panel on the front. Some are in the fridge with the controls at the top. You can turn the defrost timer till it clicks and everything shuts down. The heater should now come on. If it does, replace the timer because that means the timer is not running. If it doesn't, check the heater and defrost thermostat. Turn the timer again till everything starts back up to end the defrost cycle.
If you have an adaptive defrost control instead of a timer, replace it if the heater and thermostat test good. It is located in the fridge with the controls in some models and on the back in others.
If you need help finding your model number see here> http://www.appliancepartspros.com/modelnumber_locator.aspx
To locate your timer, motherboard, control or adaptive defrost control , enter your model number and search for the part or post back on Fixya.
Posted on Sep 19, 2009
This sounds like your defrost heating coil has gon bad. Not much you can do but replace it. Please leave a good thumbs up for me for the effort. Pretty sure I'm correct on this one. The Raz Shack
Posted on Apr 21, 2010
Tips for a great answer:
Aug 14, 2012 | Frigidaire 20.3 Cu. Ft. Frost-Free Upright...
Aug 11, 2009 | Frigidaire 20.6 cu. ft. / 583 liter...
May 26, 2009 | Frigidaire 14.1 cu. ft. Upright Freezer...
May 16, 2017 | Maytag Freezers
Jan 07, 2009 | Freezers
Aug 23, 2008 | Kenmore 13.7 cu. ft. / 388 liter Upright...
Jun 09, 2008 | Frigidaire 13.7 cu. ft. / 388 liter...
Apr 09, 2008 | Kenmore 20.3 cu. ft. / 575 liter Upright...
204 people viewed this question
Usually answered in minutes!