Disassembled shark se 450 - Shark Vacuums

The gasket sounds like one between the motor housing and a detachable dirt cup. You didn't include a model number so it's hard to get into specifics, but if it is this gasket I'm speaking to - suction power will suffer and or dirt / dust will leak out. If a different gasket - it may not be noticeable to you that anything is wrong - but gaskets are usually critical components that are used to fill gaps that might otherwise allow dirt, water, dust etc. into spaces where it shouldn't.

Hello, this is Ava with Think Crucial.

The belts for your Shark HV301 and UV450 are the same. You may order your replacement belts to us directly in this link: http://www.thinkcrucial.com/search?type=product&q=shark+belts+fit+nv350

As a special offer here is an exclusive 10% coupon for Fixya.com readers, use code: FIXYA10

Ava B.
Think Crucial Customer Care
http://www.thinkcrucial.com/

here is the manual
http://www.sharkclean.com/manual/SE400_11_IB_E_111003_1.pdf

I posted this solution explaining how to clean the heater core.
http://youtu.be/S4NglGXVv50



Based on what I found when I disassembled my S3501 it would be very hard to clear heavy mineral deposits by just squirting CLR or vinegar soak.

1) test the belt for worn or broken
2) power rollers bearing defective test and repair
3) motor need repair.
4) test the thermal fuse
5) test the main switch for open or defectie.
se the diagram

Hi,

Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it may not be getting steam to the head...

Euro-Pro Shark Steam Mop Problem

Here also is a link to get any of the Shark Manuals that you need.

heatman101

,,.,.

Hi,

Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it may not be getting steam to the head...

Euro-Pro Shark Steam Mop Problem

Here also is a link to get any of the Shark Manuals that you need.

heatman101



][][][][][][][][][][][][][][

Hi,

Here is a tip that I wrote about the Euro-Pro Shark Steam Mop and why it maynot be getting steam to the head...

Euro-Pro Shark Steam Mop Problem

Here also is a link to get any of the Shark Manuals that you need.

heatman101

I also have the Shark steamer worked great for a while lots of pressure but then pressure started coming out of the insert part for the wond not sure if its the o rings that need replaces or just the wond it self can any one help me