Hello,my Robinair 17800b is stuck in he Clr mode,can someone help me?

Question edited for clarity, and typo 'roninair' to Robinair.
Question moved from Health and Beauty category.

Here is the Service Manual

http://144.162.92.233/faculty/shop/PDFs/RA_acr2000.pdf

https://www.google.com/search?q=robinair+acr2000+enter+service+mode

Recalibration

https://www.google.com/search?q=robinair+acr2000+recalibrate+the+scale

..

Yes, that's correct. These are the most common causes for a dryer to have a light that turns on but the machine won't run. It's important to check each of these possible issues to determine the root cause of the problem and fix it accordingly. If you're not comfortable doing the troubleshooting and repair yourself, it's best to seek the help of a professional technician.

Very specialised equipment, contact their free support line.

Customer Service / Tech Support
1-800-533-6127
[email protected]


..

Manifold solenoids identification for 34788NI. Hope this will help you.

Open oil drain solenoid and clean solenoid plunger with dry soft clots and replace it. After that check the apply vacuum, if you still have same issue then you may need to replace oil drain solenoid.
Hope this will help to solve your problems.
Thank.

may be the cause is no power source, try to check voltage reading at your breaker, if the breaker itself has a power then the problem cause at your ROBINAIR, if you have guts to open the unit ?, try it and find which cause the trouble , thank you and GOD BLESS.

I had a similar problem with a Robinair 17800b. The machine got stuck in Clr or (Clearing) while changing from R-12 to R-134a. If the tank (R-12 or R134a) does not have at least 10 pounds of refrigerant in the tank before you change to another refrigerant, the machine will stay in the clearing process. I called tech support and they walked me through a process that resets the machine. The reset involves entering a code while in r-12 mode, then removing all hoses and switching the switch to R-134a mode and entering another code. The call to the tech line took about 5 mins. The number I called 1-800-822-5561.

Hi steve363,

Please follow the steps below to reset the unit to factory default.

1. Go into service mode. (*28) "Function" - "Clear". To get into service mode you might need to push "Additional Function" key. *AD>28 simultaneously and *AD again.

2. There should be an option under the clear menu for "pwd-clr".

3. Highlight it and then press OK.

4. On reboot the ID screen should have gone.

5. If not under the clear menu, please try MN-CON, that will clear the main controller.

Hope it helps.

Thank you for using FixYa.

Pls check the following: 1# With both tank vulve open, Check the refrigerant tank & make sure it has suffecient amount of refrigerant( min.6kg) to charge.2# Check charging solenoid (S-10), & Tank liquid solenoid's (S-8 & 9) it may need to rebuild.3# Check service coupler is opening properly.If all this are OK,then you may need to replace the main circuit board.Hope this will help you to solve the problem.

Just Check power cable/13A fuse & starting capacitor.