Question about Precor Exercise & Fitness

1 Answer

I have a precor efx 546 v3. battery 12v 12Ah yuasa is dead. there is a difference in voltage?

Posted by maurice van kuijck on

  • maurice van kuijck
    maurice van kuijck Jan 18, 2019

    at the charging port there is 18v displayed

×

Ad

1 Answer

Kelvin Irons

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 57 Answers

If it can be recharged it needs to be but only on a trickle charge over a lone time even a week at very low amps like 1 or 2 no more than 6 amps good luck

Posted on Jan 19, 2019

  • maurice van kuijck
    maurice van kuijck Jan 19, 2019

    i bought a new battery 12v 12Ah but at the charging port it says 18v?

×

Ad

5 Related Answers

Anonymous

  • 1 Answer

SOURCE: Precor EFX 546 elliptcal shuts off

Your problem is most likely due to the magnetic sensor on the right side of the unit under the plastic housing.
The right pedal arm, has a magnet emeded in the on the inboard side of the arm. When the arm comes around and passes this sensor at the bottom of the unit, a pulse is generated and sent to the computer.
The mangetic sensor on the frame of the unit, may need to be adjusted to a closer proximity with the pedal arm magnet. Assure the arm does not strike the magnetic sensor however.
It's also possible the sensor has come loose and fallen into the base of the unit.

Posted on Apr 19, 2009

Ad

Anonymous

  • 1 Answer

SOURCE: looking for repair manuals and error codes for

Could you please advice about ERROR 29 fo C956i/C966i treadmill.

Posted on Mar 04, 2010

Megasom

  • 699 Answers

SOURCE: new battery

A lower capacity battery (12v 8Ah) can/should preferrably be replaced by a better capacity (12v 12Ah), and usually more expensive, quality battery of the same voltage with higher amperage rating: it will in general take longer to charge but will also last longer in usage.
Please make sure that you fully charge and discharge your new battery pack a few times to 'condition' it.

Hope it helps and have fun!

Posted on Aug 01, 2010

wentlanv

Handie Andie

  • 710 Answers

SOURCE: Hi, I was hoping to

Hi Tim,

To get you started, here is the webpage for the manual for Precor 546v3

I'm still working on the other one. Check back if I don't have it posted when you read this.

Handie Andie

Posted on May 11, 2011

adamfjeld

Adam Fjeld

  • 1508 Answers

SOURCE: I need a new battery for my granddaughter's John

you can order a new one here www.powerwheelsoutlet.com

Posted on Jun 14, 2012

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can I adjust the stride length?


Precor EFX 546 Version 1 Elliptical Trainer (Refurbished)

www.amazon.com > ... > Elliptical Trainers

Amazon.com, Inc.
Rating: 4.3 - ‎9 reviews
Working out on an elliptical can burn as many calories as working out on a treadmill. ...allowing you to go forward and backward, as well as adjust stride length to target ...The Precor EFX 546 allows you to stride smoothly while holding the ...

EFX® 546i Elliptical Fitness Crosstrainer™ ' Precor

www.precor.com/en-us/.../efx-546i-elliptical-fitness-crosstrainer-33
With the unique Precor CrossRamp® technology, users can alter the path of the EFX®546i between 13 and 40 degrees in both forward and reverse stride motions, cross ...Excellent stability and freedom of movement for users of all sizes.

FAQ - Precor


Dec 28, 2015 | Precor 546 Elliptical

2 Answers

What kind of battery do i need for efx 546?


There a few possible options for the battery. This link will take you to all of them. Please have your serial number ready to help narrow your choices.

Repair Parts for Precor EFX 546i Ellipticals SPORTSMITH net

Jun 21, 2014 | Precor EFX 546i Elliptical Version 4

1 Answer

My precor efx 546 makes noise like a squeaking in left pedal it seems I tried to tighten pedal but I the whole bolt and screw turn together and the other pedal makes no noise


This squeak is normally caused by a bad bearing in the wheel. In order to provide you with the correct wheel, I will need your serial number. The following link will take you to our Precor EFX 546 page.

Repair Parts for Precor EFX 546 Ellipticals SPORTSMITH net

May 29, 2014 | Exercise & Fitness

1 Answer

Precor efx 546 wobbles when raising incline


It may be either the front shroud is installed incorrectly or broken, or the corkscrew for the incline motor is bent. If it is bent, it would need to be replaced.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/russell_1d1c35fa8a5a0be4

Feb 10, 2014 | Precor Efx 546 Version 1 Lower Body...

1 Answer

How to repair a 546 efx precor


Assuming the buttons are working, the numbers change on the display, and the incline works, it may be the lower circuit board or the generator. If it is a very old unit, it may be the electromagnet or the data cable that connects the two circuit boards.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/russell_1d1c35fa8a5a0be4

May 08, 2013 | Precor Efx 546 Elliptical Version 2...

1 Answer

Battery low


The battery is not fully charging to the 12v requirement their are a couple of screws that hold the side panels then rotate the panels counter-clockwise and they will come off. Take the battery leads off use a multi-meter the voltage on battery if it is below 12v then replace it. You may purchase this from a Precor dealer in you area if you don't have one then call Precor directly @ 1-800-347-4404 and they will help you.

Jan 14, 2010 | Precor EFX 546i Elliptical Version 4

1 Answer

Error 45 on Precor EFX 546 Elliptical


Precor Error 45, Lift Moving in Wrong Direction Probable Cause 1. Lift motor hysteresis.
2. Lower PCA is bad.
Corrective Action 1. The error would usually occur when the lift was already in motion (usually downward) when a lift command in the opposite direction (upward) was made. Some lift motors used in production exhibited a very long turnaround time and the lift motor would still be moving in the original commanded direction while the control system was trying to move the lift in the opposite commanded direction. If the error continues to re-occur, replace the lift motor.
2. It is a rare condition, however if the lift moves in the opposite direction commanded, replace the lower PCA.

Precor Error Code 45

Jul 19, 2009 | Precor EFX 546i Elliptical Version 4

Not finding what you are looking for?
Exercise & Fitness Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Precor Exercise & Fitness Experts

NOEL
NOEL

Level 3 Expert

8546 Answers

daf62757

Level 1 Expert

31 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

34001 Answers

Are you a Precor Exercise and Fitnes Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...