Question about Connex Radio Communications
It's probably a bad ground connection at the antenna. The coax shield needs to have a good ground (ground plane) or else you'll have RF feedback through the mic cable due to excessive RF traveling back down the outside of the coax and making the radio "hot".
Posted on Oct 10, 2009
SOURCE: Connex 4600 Turbo
Every tech. knows and every Connex owner Knows that once a Connex has been peaked and tuned and also had any mods done to it that the stock microphone that comes with it will not work as it should and then you will have bad feed back!! The best solution for this is buy a good Noise canceling microphone!! Such as an RK-56 or an Astatic 636-L Noice canceling microphone!! This usually will correct most of tghe feedback if not all of it!! And it will also let you keep most of your Mic gain turned uo too.
Posted on Jan 16, 2010
SOURCE: I have a Connex 4600
Had the same problem. Try backing off the RF gain just a bit (about 4 o'clock ) and set mic gain 2 o'clock or lower ...that worked for mine ..it is still plenty loud
Posted on Feb 10, 2011
check for any loose power connections.. ground connections.. loose coax.. also make sure vehicle is on so not to drain battery down when TXing. if it was off it may have dropped battery voltage down lower than it should... and turned off.. RX doesn't use hardly any ampres..
Posted on Mar 29, 2011
Tips for a great answer:
May 26, 2014 | Connex 4600 Base CB Radio
Mar 09, 2014 | Connex 3300 240-Channels Base CB Radio
Jan 01, 2014 | Galaxy Radios DX-959 40-Channels Base CB...
Nov 22, 2013 | Ranger VR-9000 Base CB Radio
Mar 18, 2013 | Radio Communications
Mar 28, 2011 | Connex Radio Communications
Nov 08, 2010 | Connex 4600 Base CB Radio
Mar 28, 2010 | Connex 4600 Base CB Radio
Mar 29, 2009 | Connex 4600 Base CB Radio
146 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: