Question about Zebra TLP 2844-Z Thermal Label Printer
HI freind tell me how to
set page height dynamic mean if my data is 4 line automatically it set height of page for 4 Line. and if i have 10 lines data then it should be set height of page only 10 lines not more than that.
please its Urgently
How are you sending the data to the printer and what type of media are you using? you can set the page hight via the ZPL command ^LL ,the value you send with ^LL is in dot, so if I wanted to set the label hight to 10cm I would send ^LL800. Or if you are printing via a windows driver configure the printer to continues media.
Posted on Dec 01, 2007
Tips for a great answer:
Nov 15, 2013 | Brother Network-Ready All-In-One Laser...
on Jul 09, 2011 | Cell Phones
on Nov 06, 2008 | Epson Stylus Multifunction Printer/...
the only way to change the password is to either login to the router and
All Belkin Router's ship without an admin password. If you require an admin password then follow the below instructions.
if you dont know your password then you have to reset the router to factory settings
Mar 06, 2011 | Belkin (F5D5231-4) Router
Feb 07, 2011 | Cisco 1700 IP ADSL Plus IPSEC 56 Feature...
The green lights next to the line or pool buttons show the current Line Ringing settings for all
lines or pools assigned to the extension. (If a line or pool is not assigned to a button, the green
light next to that button is off.) The following ringing options can be shown by the green light
next to the line or pool button:
? Immediate Ring - on steady
? Delayed Ring - flashes slowly
? No Ring - flutters quickly
3) Press the line or pool button until the button light shows the correct setting (the setting for the
currently selected line or pool also appears on the display).
4) Continue programming, or exit programming mode.
For incoming calls, the line selection (hunt sequence) is set by the local service provider). For outgoing calls....again....it depends on the system. For the Partner ACS:
1) Press FEAURE 00, SYSTEM PROG, SYSTEM PROG, CENTRAL PROG at extension 10 or 11.
2) Enter the number of the extension to be programmed for Automatic Line Selection.
3) Press **.
4) Press the line, pool, or INTERCOM buttons in the desired order. The valid entries for Automatic
Line Selection depend upon the type of extension:
? Key Extension: Outside system lines, Left Intercom (the factory setting)
? Pooled Extension: Pool 880 button 1, button 2, Left Intercom, Right Intercom (the factory
setting), Pools 881-883, individual lines
For each button pressed, a display similar to the following appears:
Automatic Line Selection
5) To exit Automatic Line Selection, press **.
6) Press CENTRAL PROG and enter a new extension number, or exit programming mode.
Changing line ringing and line selection are tasks that are normally reserved for the Administrator of the telephone system.
Jan 06, 2011 | Lucent 18D Corded Phone
Feb 05, 2009 | Avaya Corded Phone avaparp18d
Dec 13, 2007 | Brother IntelliFax-2820 Laser Fax
Jul 16, 2015 | Zebra TLP 2844-Z Thermal Label Printer
335 people viewed this question
Usually answered in minutes!