Question about Amana Heating & Cooling
The reset button is located behing a panel on the front of the unit that is labeled Heat Reset. If that label is gone then look around, it is a small hole, small enough for a paper clip to fit through.
That being said, I have 137 of these units in one of my hotels and have not had a single one needing to be reset. You probably are going to need a new control board kit. These can be purchased from Amana. They are $130. Make sure that you have pulled the heater coil out and inspected it first. Also, there was a recall years ago where Amana was supposed to contact and send out new voltage switches. These are the round black things that the Brown heater wires connect to on the upper and lower side of the heating coil. You should also try to replace those if you find the coil in good condition. I have had those resolve heating issues. Most of the heating issues were a result of a bad relay on the control board though.
Please remember to rate this fix.
Posted on Feb 12, 2009
open your control area,
check your l1 and l2 conections this unit is usually 220v
the control is this simple
voltage in no voltage out change the board
Posted on Oct 24, 2009
Tips for a great answer:
Aug 21, 2015 | Amana Heating & Cooling
Feb 02, 2013 | Amana In Wall Install Kit For Digismart...
Jun 02, 2012 | Amana PTH123B25AJ Heat Pump Air...
Nov 27, 2010 | Amana Heating & Cooling
Jun 19, 2010 | Amana PTH093B35AM Thru-Wall/Window Air...
Mar 26, 2010 | Amana PTH123B50AJ Heat Pump,12000BTU,...
Jan 28, 2010 | Heating & Cooling
Oct 24, 2009 | Amana PTH123B25AJ Heat Pump Air...
66 people viewed this question
Usually answered in minutes!