Question about Johnson Boating

Open Question

What operates the choke on a 1995 Johnson hj115

Posted by Frank stubbings on


Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Installing a carb on a 1991 3 HP johnson. Does the choke insert in the linkage round hole or the oblong hole?

Hey Rocky, I would start with the round hole... This is a manual choke engine/carb..(butterfly in the mouth of the carb)... make sure it opens fully and closes fully when you turn the choke knob needs to operate smoothly and correctly..if it doesn't swap holes..┬žion=Carburetor

Jul 17, 2017 | HP Garden

2 Answers

70HP JOHNSON OUTBOARD doesn't want to run with cowl on.

There is an air inlet at the upper back side of te cowl. Check if that is open...

Mar 07, 2014 | Seloc Marine Johnson Evinrude Outboards,...

1 Answer

Change question

sounds like a fuel venting problem. Loosen the cap to the gas can and see if that works.

Then (if that fixed it) you will find the vent built into the cap is sticking shut or you forgot to open it.

Sep 25, 2012 | Seloc Johnson Outboards 2002-2007 Repair...

1 Answer

9.9 johnson 4 stroke wo'nt idle

Your cabs need rebuild, something is stuck in the carb or air line cracked

If you have rebuilt the carb check for carb gaskett leak that caused and let the air flow in
When to choke is on the air is block and prevent air flow but allowed small amount of air to keep the engine running
After your engine warmed up the heat in the compression burn much faster so you have to let air in by turn off the choke
Good luck

Aug 19, 2009 | Boating

1 Answer

70 hp Johnson hard to start.

could be the choke isn't closed all the way for the first start. Then when warm the motor doesn't need to be choked.

Jul 25, 2009 | Sport & Outdoor - Others

1 Answer

Boat engine 1995 Johnson Outboard 70 HP

Ihave a 1991 70 hp Johnson outboard thats hard to start the first time but starts good after that. Seems to be flooded. Starting rpm seems to be low.

Jun 25, 2009 | Boating

1 Answer

1995 Isuzu Rodeo starting problem.

Hello first thing i would start with is check your idle screw it may be set to low if the choke linkage is sticking .first take your breather off so you can see the choke linkage look to see where the plate is positioned is it fully closed have somone try starting with out touching the gas pedal if it doesnt start slightly open the choke plate if it starts you need a choke adjustment check to see if its manuel linkage, vacuum operated,or electrical. if vacuum check lines for dry cracks or splits preventing choke operation if electrical you need to test the power wire at the choke also test for good ground if mechanical check adjustment screw for curb idle to see if its set to low.goodluck please rate

Sep 29, 2008 | 1999 Isuzu Rodeo

Not finding what you are looking for?
Boating Logo

Related Topics:

157 people viewed this question

Ask a Question

Usually answered in minutes!

Top Johnson Boating Experts


Level 3 Expert

85239 Answers

Lawrence Oravetz

Level 3 Expert

10548 Answers

Brad Brown

Level 3 Expert

18562 Answers

Are you a Johnson Boating Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides