I can't turn the alarm off on my digital wall clock

To turn off the alarm on a Sterling & Noble round wall clock that shows the time, date, and temperature, click on Mode so that it goes to the alarm screen then click on the Up or Down button to turn off the alarm. Click Mode again to go back to the regular time.

Honestly, no idea, but I would look for instructions on.line i you provide make and model.
Also you can make a google search using term manual, make and model

U get a new alarm clock

On my similar model, there are 4 buttons on the back. The 3rd button starting at the left is labeled ALM. You should be able to turn the alarm off by pressing that button.

1- Turn over your Seth Thomas digital clock. Use your finger to remove the cover to the unit's battery compartment. Insert two AA-size alkaline batteries into the battery compartment and replace the cover. Certain Seth Thomas digital clock units will also have an optional alternate power source in the form of a standard AC power cable that plugs into a wall outlet in your home.

2 Place your Seth Thomas solar-powered digital clock in front of a light source, such as on a window sill or beneath a lamp. The black strip on the top of the unit is the solar sensor, so as long as light is shining down on that strip, your clock will be powered on and ready to use. The sensor stores energy throughout the day so that it can work at night with no direct light contact on the sensor.

3 Press the time zone button that indicates your current time zone. These buttons are located on the back of the unit. For example, if you are in the eastern time zone select the "EST" button. Turn the unit back over. It will now be displaying the correct time on its digital screen.

4 Use the "Alarm" switch (if applicable) to enable and disable the clock's alarm. Press the "Alarm" button, followed by the "Hour" and "Minute" buttons, to set the appropriate alarm time based on your needs. Use the "Alarm HI LO" switch to set the volume for the alarm.

5 Press the "Weather" button to tune your Seth Thomas digital clock to its built-in local weather radio station (if applicable). Certain Seth Thomas clocks have this radio weather functionality built in, while others don't. If yours does, the aforementioned "Weather" button will be located on the front of the unit.

TO SET ALARM:

Press mode to go to alarm screen (AL shows above temp)

Hold the alarm on/off button for about 5 seconds and the hour will flash.

Press the adjust button to change the hour.

Press the alarm on/off button again to move to minute

Press the adjust button to change the minutes

Press the mode key to save and exit
Good Luck and please rate 4 thumbs for the free answer

How do I turn off the alarm clock on model number 87315? [email protected]

Most atomic clocks simply receive the National Institute of Standards and Technology (NIST) time signal. They do not all allow for daylight savings time changes as not all areas use it.

You will have to adjust manually.

After replacing the transmitter batteries several times, I tried replacing the clock batteries. They must have been getting low. Once I put in new batteries in the clock it worked fine. Good Luck.

I have a sharp 12 inch atomic clock...cant get it to reset and dont have instructions...please help