Televison & Video Logo

Related Topics:

Question about Sony BRAVIA Televison & Video

1 Answer

Sony 49 XBR 900 E power will not come on unless the plug is taken out from the set and reconnected. Can you tell me which board should be replaced?

I would like to order the replacement if I can get an answer.
Is is the main ? or the Power?

Felix C

Posted by Felix Cavaliere on

Ad

1 Answer

Larry Ng

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Sony Master
  • 7,653 Answers

What plug not told./
PC is dead?
no it is not a PC it is a television posted to wrong forum
now corrected.

is TV set to sleep mode, RTM read the manual on TV
are the clicker remote batteries fresh>?

Posted on Mar 24, 2022

Ad

5 Related Answers

Anonymous

  • 447 Answers

SOURCE: Replacing the main Board to eliminate howling noise

I have had a number of these complaints and I have always repaired it by replacing the evap fan motor. It is a much cheaper part, however, its way more difficult to install than the main board. Yes many other techs say it can be resolved with a new main board and yes it is just a matter of plugging the wires in. I would be very interested to see if indeed it does resolve the howling. It will come with an instruction sheet that says you will need to cut a wire from one of the harnesses. Just disregard this if indeed your model is the one that you selected and is fairly new. (PSS26msr). If you would like to take advantage of my employee discount I can send you the part for $100 plus $20 shipping. Just let me know.

Posted on Jan 19, 2008

Ad
enda story

niall ginnity

  • 61 Answers

SOURCE: How to replace a power adapter on a Dell E171FP LCD

this is a monitor you shuld not open this as it has very high power running thru it. get dell onto it

Posted on Apr 24, 2008

Tech4lfe

Neil Frazier

  • 42 Answers

SOURCE: Main Power Board

The power supply board can be changed without any knowledge of repair but there are sometimes adjustments necessary if the picture is not normal. Many times it is fine. There a 4-5 voltage adjustments that would take some knowledge and a meter to accomplish. You need to hope it was diagnosed properly first. If it is completely dead the p.s is a good possibility. If it clicks on then back off almost immediately it is not likely the power supply.

Posted on Jun 23, 2008

Anonymous

  • 4 Answers

SOURCE: I have a dead E151FP monitor...need either a schematic or another damaged monitor

You can get repair instructions for the Dell E172/E151FP at ezinearticles.com and order transistors at AnBparts on ebay.

Posted on Sep 05, 2009

Anonymous

  • 1 Answer

SOURCE: Power Problem with Zenith Z50PX2D

I had the same problem with same model TV a year back, they replaced some board (I was not there at home) as I had warranty and after a year same issue popped up again.. Can you please tell me what board replacement worked for you. I don't have warranty anymore.

Posted on Feb 15, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a Sony 65 XBR-65X850B non-android and all of a sudden it would click off and click on simultaneously. Any idea on what the problem would be?

It amazes me how many people change boards not knowing much about fixing TV's or how the boards work and what each is supposed to do, such a waste of money. According to Sony service information you're getting the code for over current draw of the LED backlight circuit. Several diodes in the strip are bad, this set is edge lit it only has one strip with a defusing screen to spread the light. IF you can find a replacement strip that should fix the set but like most Sony parts they are expensive and hard to find in a lot of cases. If you find one another thing to watch for is getting the defusing screen back in correct or the picture won't look right, also the screen is quite heavy in this set and must be handled with suction cups, if you try to remove or replace it without them there is a good chance you will break the screen.
0helpful
1answer

SONY TV will not power on.

Measure the output voltages from the power supply section first. That will tell you which way to go forward.
0helpful
1answer

Sony xbr-49x900f tv has sound but no picture after a min or shorter

Hello
in this case ld board is defective please replace ld board .
thanks
M Nasir
0helpful
1answer

Sony xbr 55-810c I have replaced the power board the t-con board I don't have a pic just black screen any help would be appreciated

Hello Dear
please update the sw hopefully your set become ok if problem still there please replace panel
Thanks
M Nasir
0helpful
1answer

Sony videoscope xbr

would think you need to replace the cable board etc. the signal is not getting in and out right. can also be a fault on the power board giving the wrong volts so would check this to. it will tell you on the board what volts is supposed to be. the 5v and 12v should be spot on other volts will vary a little. also check the capacitors for the caps to be bowed up and a brown/ yellow gunk around them and under the board this can be a sign they are failing.
0helpful
1answer

2002 36" Sony Trinitron XBR High Def TV. When you

Hello,

Your power supply board is dead, do you know basic electronics' and soldering? Most of the times, the power supply board just have dead leakages gases capacitors.These capacitors always bulges up on it top,or puff up on it top.Replaced these gases leakages capacitors will get your TV power stable,and work again.Or tries websites like Shopjimmy.com,Ebay.com to buy a whole refurbish power supply board for the replacement.

I hope this will help in solving the problem..
1helpful
1answer

I have a 46 inch Sony Bravia 46 XBR4 set. The right side went out only colored lines appear. The rest of the screen is fine. email address [email protected]

Sounds like the tcon (timing control) board. Sometimes unplugging the LVDS cables from the tcon, cleaning and reconnecting solves this. The catches on the LVDS cables are easily damaged and must be handled carefully.
0helpful
1answer

I was watching a dvd on my week-old Sony Bravia XBR-52HX909 for the past three hours when the screen suddenly went blank. The standby indicator light in red started blinking. I attempted to turn on the...

This tv only a week olds,should never having this problems already.The tv should be return and get a new tv for the replacement,this tv have tv Tuner signal board or tv power supply board distrubution problems.Even when the store test it out it work,don't take that tv back.Insit they give a new tv for the replacement.
0helpful
1answer

Sony 52 Bravia XBR4-14months old,picture very white, ghosting

Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Pull up older posts.
http://electronicshelponline.blogspot.com/
In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary
Not finding what you are looking for?

156 views

Ask a Question

Usually answered in minutes!

Top Sony Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76835 Answers

Ekse

Level 3 Expert

13435 Answers

Nasir Muhammad
Nasir Muhammad

Level 2 Expert

252 Answers

Are you a Sony Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...