LG Washer Dryer F1403RD low drying efficiency. Any ideas

A lot of the times if a dryer starts taking numerous cycles to dry clothes it is because the vent to the outdoors has become clogged with lint. This keeps the dryer from being able to discharge the moist air. You can buy dryer vent brushes with a wire attached that you can use to keep the vent clean.

Broken drive belt tho your model number is not for a dryer.

This caused by one of two possible things. Either you have poor air flow, or a clogged vent preventing air from flowing freely and therefor making the dryer short cycle, which in turn will take you two or three times to dry yor clothes, or the heating element has gone bad, burnt in half and is making contact with the case to provide it just enough power to barely heat. The second thing is a very rare occurance. I would turn the dryer on, find out where the air vents out to, and with the dryer running, go to where it vents and check to see if there is a strong flow of air. 9 times out of 10 that is going to be your problem. Another way to check air flow is to just pull the vent off the back and let the dryer run and see if your clothes dry faster. If you do it that way and they still take a long time to dry, then you'll probably need to replace the heating element

If you need further help, I’m available over the phone at https://www.6ya.com/expert/jason_4570d45317834dd3

Since I am not there to troubleshoot the problem, here is a website:

http://www.partselect.com/dryer+dryer-wont-heat+repair.htm

Hi,
I am using LG Tromm DLE2514 washer dryer. It 's running but didn't dried the clothes. I clean it's lint but still it's not working. The one thing i notice now is it's drying light is blinking and cooling light is turn on all the time during the cycle. So what's the problem with my dryer?

mine is doing the same, did you figure this out?

I would check your venting to make sure its not clogged. This will cause longer dry times because the dryer cant efficiently remove moisture. Just go outside and feel the air coming out it should be fairly strong, if not the replace or clean your vent line. Good Luck

weak pump...but remember in the drying cycle water is ment to come in and flush out lint and produce air flow for drying..it also cools drum..

the unit is made to bring water in in the drying cycle ,,the water dont touch the clothes..the water is to take the lint away and to cool the drum,,you must remember that you can was 22 pounds but you can only dry 11 pound..so you must dry about half of what you wash..and drying the 11 pounds it will take 3 to 4 hours,,no exhaust...

it may be possible the contol is bad can you change the settings at all