Model 3320. How do I reset the pickup roll counter?

possible that the counter is not reset after putting the new roll of film in the camera

search trought service manual and see service menu for reset counter for pickup roller

You need to run Qumatool to reset the counter

S. Mohan

For some other Samsung CLP printer types it works like this:

1. Enter tech mode Menu>up>left>ok>right>stop>menu
2. Select Data Setup
3. Select Counter Reset
4. Select Fuser
5. If it asks, select OK.
Once it has gone through the process just go back to main user screen.

hi you can use master reset code to reset your nokia mobile you can get the codes from here unlock-free
here they ask the following details before rendering the codes they are
1.mobile model
2.imei number of the mobile
finally they will send you the master reset codes at free of cost.

This won\'t be easy for you if you don\'t the proper tools, You have to remove the wind lever assy, and the speed dial, Then wind side top cover, Then pull wind base plate assy, And check counter reset lever, to make sure spring didn\'t come loose, Putting the baseplate back on can be fun because of linkage to the wind assy

After printing 215,000 pages, the MFP alerts you to order a maintenance kit. The message can be
temporarily cleared for approximately 10,000 pages by using the CLEAR MAINTENANCE
MESSAGE item on the RESETS submenu. When the page count reaches 225,000, you can no
longer clear the message and you must install the maintenance kit. To check the number of pages
that the MFP has printed since new maintenance-kit components were installed, print either a
configuration page or a supplies-status page
the maintenance kit is Fusing element , pickup rolls for all trays, and transfer corona
To reset the maintenance-kit counter
1 Turn the MFP off and then on.
2 When the memory count appears on the control-panel display, press and hold 6 until all three
LEDs flash once and then stay on. (This might take up to 20 seconds.)
3 Release 6 and then press 3.
4 Press 6 to select NEW MAINTENANCE KIT.
5 The MFP completes its initialization sequence. The maintenance-kit counter is automatically reset.

The drivers for the 3300-series are right on HP's website. The link below is for Windows, OS X, and Linux. If problems continue, look further down the driver page for the OCR libraries.

http://h20000.www2.hp.com/bizsupport/TechSupport/DriverDownload.jsp?lang=en&cc=us&prodNameId=66364&taskId=135&prodTypeId=18972&prodSeriesId=66359&lang=en&cc=us&submit=Go%20%C2%BB

If the link above is broken, go to http://www.hp.com/#Support and type in your hardware's model number or series number (e.g. Laserjet 3320, Laserjet 3300 series)

Unfortunately you cannot reset those electronic counters.
I'd suggest reloading the firmware to try and solve the issue going forward.

Thanks!

I had the same problem. Shorting the three terminals really worked.