Question about American Standard Home
SOURCE: The heat pump stays on
Remove the cover of the circuit board and controls on the outside unit. Some units have a thermostat that allows you to set the temperature at which it switches to the second stage of heat. Set that for about 34 degrees.
Posted on Jan 03, 2011
SOURCE: I had a new American
INSTALLER SETUP 1. Press SYSTEM. 2. Press and hold these two blank buttons until the display changes. You will have 5 buttons at the bottom of the stat..... Press the two blank button on either side of the middle blank button till the display changes and then scroll down to 0300 and use the up and down arrows to change from 0 to 1 push Done and you should now have Auto.....if you have other ??? look up a Honeywell Pro 8000 stat it will have the same features... http://customer.honeywell.com/techlit/pdf/69-0000s/69-1871.pdf
Posted on May 05, 2011
Nov 27, 2017 | American Standard Water Heaters
Sep 09, 2016 | American Standard Home
Sep 30, 2013 | American Standard Plumbing
INSTALLER SETUP
1. Press SYSTEM.
2. Press and hold these two blank buttons until the
display changes. You will have 5 buttons at the bottom of the stat..... Press the two blank button on either side of the middle blank button till the display changes and then scroll down to 0300 and use the up and down arrows to change from 0 to 1 push Done and you should now have Auto.....if you have other ??? look up a Honeywell Pro 8000 stat it will have the same features...
http://customer.honeywell.com/techlit/pdf/69-0000s/69-1871.pdf
May 05, 2011 | Heating & Cooling
Jan 02, 2011 | Heating & Cooling
Nov 05, 2010 | 1998 Isuzu Hombre
Feb 24, 2010 | American Standard Cadet 3 Round Toilet...
Dec 01, 2009 | American Standard Colony Round Countertop...
Mar 23, 2009 | American Standard 2083.102 Standard...
125 people viewed this question
Usually answered in minutes!
×