07bmw eas sensor replacement - Video Game Consoles & Games

run the fasult codes to see what was done incorrectly when the job eas done

Check your sensors or wiring that might be loose or attach to something

Stop letting people talk you into cr@ppy springs - the vehicle has a EAS for good reason.

After checking the air tanks and air lines for leaks do the following:-

1- get a new compressor or get a compressor repair kit plus a new relay switch - easy install + if that works - fine, if not
2- purchase new US made air bags from Arnotts and check the struts when replacing the bags - if that works - fine - if not
3- check & replace the 4 EAS sensors.

The only other fault could be with the computer module itself.

installing springs is a loser's fix - you might as well just go buy yourself an ox wagon.

If you look on Napa.Com,it shows $104.00 ea

for the front ones (closest to engine)

I wouldn't pay someone to do that

It is a 10 minute job and $104 is expensive
for an O2 Sensor or two ,if you have two

if you have an EA account and legally purchased this from EA or a retailer then you can contact EA via telephone support.
866-543-5435
talkign to them you can provide them your account information and they may, without cost, replace the cdkey. EA is a very odd company you may just have to repurchase the game.

O2 sensor $75.00 up to =$150.00 labour one hour $80.00 an hour give or take $10.00 or twenty dollars an hour

You must be getting that price from the dealer. A/P stores show them from about $35.00/ea to about $72.00/ea. If the sensors are whats wrong, you will do just as good to use the aftermarket part as the dealer iem.

mine were corroded, but passed a continuity test. removing the corrosion opened a hole in one of the cases. $30/ea to replace (parts only). then i read how the brass 'screw' they contact with are prone to corrosion (salt pool), not listed in the parts manual, but are available as part# R0383200 (another $6/ea). not a happy jandy/laars/teledyne owner.

A Tech I called said auto sensor was the tach on the motor.

Check for proper resistance across pins 3&4 at the motor plug (2 red wires). Should be 150 ohms.

If proper resistance, could check connections at board and board itself.

Though I wonder what the error would be if the motor wasn't turning and this looked like an error with the tach. Would this this be an EA error too?