Question about Sharp Refrigerators

1 Answer

How do you clean the heat exchange coils on the Sharp Model SJ-2255 refrigerator? Where are the coils located?

I tried to look under the fridge but there is no clearance from the floor and i did not see the coils

Posted by Jackie Wiesner on


1 Answer

ray gallant

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Sharp Master
  • 68,246 Answers

If you do not look under it you will never know and many use a vacuum cleaner or air compressor to blow them off

Posted on Aug 21, 2018


5 Related Answers


Glenn Rogers

  • 859 Answers

SOURCE: I have a 4 door

From my search the only Sharp Regrigerators are sold in Australia and NZ. Here's the list of spare parts outlets:
State Spare Parts Wholesalers Contact Details Queensland Prime Electronics- Bowen Hills
24 Campbell Street
Bowen Hills QLD 4006 Phone: 07 3252 7466
Fax....: 07 3252 2862
Email: [email protected] New South Wales Prime Electronics- Flemington
185 Parramatta Road
Flemington NSW 2140 Phone: 02 9704 9000
Fax....: 02 9746 1197
Email: [email protected] South Australia Statewide Appliance Spares
178 Sturt Street
Adelaide SA 5000 Phone: 08 8231 3369
Fax....: 08 8212 3195
Email: [email protected] Victoria Speedy Spares
451 Macaulay Road
Kensington Vic 3031 G.B. Telespares
5 Hunt Crescent
Clarinda Vic 3169
Phone: 03 9376 1333
Fax....: 03 9376 7110
Email : [email protected] Phone: 03 9512 7604
Fax....: 03 9512 7534
Western Australia WA Appliance Parts
135 Russell St
Morley WA 6062 WA Appliance Parts
1/9 Blaikie St
Myaree WA 6154
Phone: 08 92754755
Fax:...: 08 9275 4935
Email :[email protected] Phone: 08 9330 1999
Fax:..: 08 9330 1677
Email :[email protected]

Regards and hope this was Helpful,

Posted on Jun 02, 2008


Chandler Ede

  • 1420 Answers

SOURCE: Goodman furnace model #GPO 125_4 REV 8 Installed 6/2/2002

Have you measured the temperature in the suppy plenum? Should be 140 to 160 max. If hotter, you have a blockage in the ductwork or vents closed. If within spec, bad circuit board.

Posted on Jun 10, 2008


  • 1 Answer

SOURCE: Maytag PBF 2255 HEW refrigerator defrost timer location?

These look like schematics that might help you.

Posted on Dec 27, 2008


  • 49 Answers

SOURCE: How do I get access to the coils on an Amana model SXD22S2W,

on most refrigerators the plastic grill is a snap on most service tecks carry a long
brush that looks like a cats tail to clean the condenser coils a long bottle brush will also work but be gentle the tubing is metal the fan is normally located looking from the front back left corner if you have a plastic putty knife you can insert on top behind plastic close to the side and easily pop forward very few units are secured with screws ron

Posted on Dec 06, 2009

Cindy Wells

  • 6112 Answers

SOURCE: how do change the

Unplug the refrigerator. Remove the lamp cover by lifting up at the bottom of the cover. Then unscrew the old bulb and replace with an identical appliance bulb (Base E12, 240V, MAX 15W, T-20). This bulb is at the top center of the fridge.

The manual is available here: . You will need to review the fridge or enter a code to download the PDF. The light replacement instructions are on page 6.

I hope this helps.

Cindy Wells

Posted on Feb 25, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Freezer has ice on floor

if there's ice on the freezer floor it's usually caused by a blocked drain,when the fridge goes into defrost a heater comes on and melts the ice off of the evaporator coil,under the coil there's a drain,this can get blocked,the water can't drain into the drain tube and the water leaks onto the freezer floor,next time send the brand name and model number.some machines newer bottom mount freezers you have to change the drain tube,if it's an older fridge this happens,you have to melt out the drain and clear the tube,i use a steamer to do this but you have to shut the fridge down,get at the drain melt it out with hair dryer then you can try a turkey baster to push water through the drain hose and see if it clears,sometimes you might have to remove the back bottom panel,find the drain tube and snake a plastic wire tie up into it to clear the junk in there.hope this helps.

Dec 05, 2017 | Refrigerators

1 Answer

When it is lcooling it has now begun tomake loud vibrations.

it is most likely from the frame of the fridge that the compressor is mounted on vibrating on the floor
I use two door wedges ( available from the hardware shop and I push one under either side a bit to get clearance from the floor
the noise stopped but the problem is that there is nothing available on the market to replace the wedges
rubber buttons under the plate worked but to stop the noise they tend to make the fridge unstable when opening the door or the front of the fridge has to be adjusted up so that the door self closes
try that and if it works the you are on the right rack
if not you may have to get the compressor rubber mounts replaced as they may have collapsed and allow the compressor to hit on the plate

Oct 14, 2015 | Maytag MSD2454G Side by Side Refrigerator

1 Answer


The evaperator for the drip under the bottom of the unit is probably dirty or has gone bad. Pull the fridge out and look under the bottom and you should see a pan with a coil above it. Clean the coil and the pan. If this does not correct the problem, then a new coil is in order. Also vacuum the back of the fridg if it has exposed coils to increase efficiency.

Dec 15, 2014 | GE Refrigerators

1 Answer

Fridge wont come on

Yo Arron, move the fridge away from the wall far enough to set a box/window fan behind it on the floor with the fan blowing air under the ridge. Turn fridge on or plug it in, if after a little while the fridge does come on, with the fan blowing across the coils underneath, then you just need replace the little fan that's under the back rear of fridge. This test setup works every time.

Oct 07, 2014 | Electrolux E32AR75JPS

1 Answer

Hello how do you change the spark plug on the drivers side rear of a 2006 chrysler sebring the wiper pand is to low to get the coil and wire out of the hole...????

Place a floor jack under the transmission pan. Loosen the transmission mount bolts. (don't remove them completely) Lower the engine and transmission to provide clearance to remove the ignition coil.


Aug 04, 2011 | 2006 Chrysler Sebring

1 Answer

Do you need clearance at the sides when installing fridge (very close fit)

it is better to have some clearance on the side of at least a couple of inches but i have seen them work fine without it. i would think as ong as you routinely keep the coils under unt clean and that will reduce the heat on the coils and compressor you will be ok...

Jan 05, 2011 | Refrigerators

1 Answer

Water in carpartment under fridge.

thats the dispensor tank, is there a drip pan under neath the refrigerator?

Apr 24, 2010 | GE GSH25JFR Side by Side Refrigerator

1 Answer

Occasional small puddle of water on floor in front of unit on door handle side. it is a 25 yr. old Amana no ice maker or water dispenser in door

there is a drain pan for condensation under the fridge. over this many years the is dust and lint that will fill the pan and displace the water on your floor. while your under there clean the coils. this will help get every year possible from your fridge

Jul 27, 2009 | Refrigerators

3 Answers

Kenmore Elite Bottom Freezer Refrigerator Model 795.7554

the condenser coil on this is located in the back side and removal of the rear cover is need to get to the coil. It's on the right side looking at the back. make sure to unplug the ref before taking the back off.

Aug 09, 2008 | Kenmore Elite 22.4 cu. ft. Bottom Freezer...

2 Answers

Frigidarie fridge

Coils location is in one of three places;
1. under the refrigerator compartment in the back, must remove fiber panel to access. If this is yours be sure to replace the panel after cleaning.
2, Black grill on back of refrigerator about 1.5" stand-off from back.
3 built into the outer walls of the refrigerator, Not accessible, provide air clearance for free air circulation around unit.

May 12, 2008 | Kenmore 73502 / 73504 / 73509 Bottom...

Not finding what you are looking for?
Refrigerators Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sharp Refrigerators Experts

Vernon Taylor

Level 3 Expert

6531 Answers

Brad Brown

Level 3 Expert

18360 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

32927 Answers

Are you a Sharp Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides