Question about Frigidaire Kitchen Ranges
So is there another way to convert the oven side for propane?
The method when converting gasses is to use different jet sizes required for the new gas in use
it also means that the air shrouds have to be adjusted to maintain the correct burn ratio and get a blue or colorless flame and a possible adjustment or the pressure regulator
Gas is NOT in the domain of the DIY and only a qualified accredited gas fitter should be doing the job
Posted on Aug 11, 2018
To prepare the new unit for LP gas you need to adjust several items. First you will need to replace the range orifices or spuds. These are individually sized with marks and colors.
Using a nut driver, loosen the old spud and replace with the new one.The trick to keeping from dropping the spud down inside the range is to use a small piece of aluminum foil between the driver and the spud. This should provide enough "grip".
If you do drop one down inside, you'll need torx wrenches to disassemble the burner units and get inside.
The oven orifices need to be adjusted. Using an open-end wrench, tighten down the brass fitting on the oven burner valve.
There may be two orifices, one for the broiler and one for the main oven burner.
You will need to reverse the plastic pin in the regulator underneath the range. Remove the hex nut and flip the plastic pin and reassemble the nut.
Do not over tighten!
The last step is to open the air shutters on each burner as per directions included with the range conversion kit.
Posted on Nov 07, 2007
I needed parts for my GE XL44 propane converted stove. This site was very helpful. I found the part and there is online live help or toll free help. Go to: AppliancePartsPros.com
Posted on Jan 29, 2009
SOURCE: dryer has been converted to propane using conversion kit #131776600 and I need the info needed to get it back to run on NG The dryer is a Fidgaire Gallery series model #FDGC648GHS0 any help greatly a
Hello there. If the parts were saved, they can be reused. If not, contact your propane provider and tell them that you plan to convert back to natural gas. They will be able to get you the kit you need, and will possibly have a technician come out and install it for a fee.
Posted on May 27, 2009
What you do is tighten down the spud on the oven safety valve.
Get a good wrench and in the case of propane or LP you tighten down clockwise on that spud. Then open the air shutter all the way.
If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61
Posted on Nov 21, 2010
Tips for a great answer:
Dec 20, 2015 | Whirlpool Kitchen Ranges
Aug 29, 2015 | Frigidaire Kitchen Ranges
May 23, 2011 | Frigidaire FD27LKEC (LP) Grill
Nov 21, 2010 | Frigidaire Kitchen Ranges
Aug 11, 2010 | Frigidaire FGF316 Gas Kitchen Range
Jun 10, 2010 | Sears 61301 Gas Kitchen Range
Sep 04, 2009 | Ovens
Dec 19, 2008 | Jenn-Air JGR8855BDS Gas Kitchen Range
Nov 03, 2008 | Frigidaire Ovens
142 people viewed this question
Usually answered in minutes!