Hi can someone please help me out. Im trying to find out is there a 100% per cent site that i can look up to if my husband is cheating on me. He been really strange and it's like he doesn't want to sleep in the same bed or touch me for about three months now. Please help i need to find out the truth

I don't know if it has changed, but we used to say "of" means
"times" and percent means "per cent" or "per one hundred" (100 pennies in a dollar)so to convert a percent to a fraction, we just divide it by 100.

Thus we have 20% x $60 or 20/100 x 60 or $12.
Good luck,
Paul

Not all calculators have a percentage key. I think of percent as per cent, or per 100. You can always multiply by 100 to get the percentage.

For example, 0.23 as a percent would be 0.23 x 100 or 23%.

Good luck.

Paul

go ahead and turn it off and restart it windows 8 hangs up sometimes when updates load it wont hurt it to restart it

go ahead and restart it,

The voltmeter test provides general indicator of battery condition. Check the voltage of the battery to verify that it is in a 100 per cent fully charged condition. If the open circuit or disconnected voltage reading is below 12.6 V, charge the battery and then recheck the voltage after the battery has set for one to two hours. If the voltage reading is 12.8 V or above, perform the load test described below.



The load test measures battery performance under full current load and is the best indicator of battery condition. Load testing a battery tat is not FULLY CHARGED i.e. at 12.8 VDC can permanently damage it. Fully charge it first and then let it stand for at least an hour before the load test is done. You also need a load tester AND you should know how to perform a load test. Often the best way to load test a battery will be to take it to a battery shop and have it done there.



VOLTAGE and STATE OF CHARGE FOR AGM BATTERIES IS:

12.8 VDC is 100 per cent

12.6 VDC is 75 per cent

12.3 VDC is 50 per cent

12.0 VDC is 25 per cent

11.8 VDC is 0 per cent



COLD CRANKING AMPERAGE (CCA) for a DYNA battery is 270

Battery Charging Rates/Times (Approximate)



FOR A 19 AMP HOUR DYNA AGM BATTERY



BATTERY STATE OF CHARGE is 12.8 VDC is 100 per cent Charge; Rate of Charge is N/A



BATTERY STATE OF CHARGE is 12.6 VDC is 75 per cent Charge; Rate of Charge at 3 AMP is 1.75 hours at 6 AMP is 50 minutes at 10 AMP is 30 minutes at 20 AMP is 15 minutes



BATTERY STATE OF CHARGE is 12.3 VDC is 50 per cent Charge; Rate of Charge at 3 AMP is 3.5 hours at 6 AMP is 1.75 hours at 10 AMP is 1 hour at 20 AMP is 30 minutes



BATTERY STATE OF CHARGE is 12.0 VDC is 25 per cent Charge; Rate of Charge at 3 AMP is 5 hours at 6 AMP is 2.5 hours at 10 AMP is 1.5 hours at 20 AMP is 45 minutes



BATTERY STATE OF CHARGE is 11.8 VDC is 0 per cent Charge; Rate of Charge at 3 AMP is 6 hours, 40 minutes at 6 AMP is 3 hours, 20 minutes at 10 AMP is 2 hours at 20 AMP is 1 hour



The figures listed above assume that the battery is charging at room temperature. If warmer than room temperature, use a slightly shorter charging time. If colder, use a slightly longer charging time.



The use of constant current chargers to charge maintenance free batteries is not recommended. Any overcharge will cause dry out and premature battery failure. If a constant current charger is the only type available, do not exceed the charge times listed above and do not continue charging the battery if it gets hot. When charging, never exceed 15 volts for more than 30 minutes.



If the battery gets hotter than 110 degrees F or 43 degrees C during charging, discontinue charger and allow the battery to cool. Overheating may result in plate distortion, internal shorting, dry out and/or other damage.

Try this one: super saiyan

3,000 experience, once per round.

Hi,

Wattage is simply calculated by multiplying voltage by amperage. Look on the back of your system, and it will say how many amps the system uses. Often, it will also provide the wattage. For instance, the back of a ViewSonic E220 is 2.5A at 120V - ~300 Watts/Hr. An average rate is 10 cents per kilowatt hour, or 3 cents per hour to leave your monitor on. or 72 cents per day.

A computer system can use between 150 and 600 or more watts per hour. Together, it could cost between $20 and $60 a month

Read more: Click Here


* Please rate this solution with Thumbs up and Testimony to help us improve providing support

im not 100 per cent sure but do you have 2 start lead connections (they look like this) If you do, plug the lead into the other plug (in the pics case, the blue one above)
I have to do this with my xbox becuase my tv has 2 plug sockets- one only lets image but no sound, and the other is both. try it and let me know if it works.

Are you using the DIVX Codec for watching these downloaded movies? Go into the configuration of the decoder, find the 'deblocking' setting and change it to "none".