My frigidaire ranger is new.the flame on the cook top is to high.I adjust the flame to lowest position(clockwise)The flame is still to high.Please help me.Thnk you.Baky.

Douglas Henry

• 175 Answers
• Posted on Oct 31, 2006

SOURCE: gas cook top

Most of the time when I come out for a service call with this problem, it is usually because the burner cap is not seated properly on the base. Look at the burner and make sure there are no uneven gaps. Most of the time you will have to rotate the burner cap till a notch or pin "seats" into place. Most burner caps just sit on the bases, and so they get knocked off or moved when the cooktop is cleaned or installed. Hope this helps!

Ron Coons

• 2651 Answers
• Posted on Mar 17, 2008

SOURCE: cant find the set screw to adjust the flame

some arent adjustable any more, did you look down the center of the knob shaft???? most common place for it

SOURCE: Propane gas flame too high

if it set up for propane or natural gas need to make sure if for propane you need to change the orifice in the cook top, it is shipped for natural gas call the store and they can order the kit

SOURCE: flames are extremely uneven and high

okay, DO NOT USE THIS STOVE ON LP GAS.

It's not intended to be used with LP gas, because LP gas requires a smaller orifice than natural gas. Call your propane supplier IMMEDIATELY...DO NOT USE THIS STOVE UNTIL IT IS CONVERTED TO LP GAS (if it's even possible)...this is extremely dangerous and you could hurt yourself if you continue to use LP gas on a stove that was designed to run on natural gas.

SOURCE: OVEN FLAME TOO HIGH

HI, To adjust the size of the flame, turn the orfice clockwise to make it smaller. you can also try and adjust the air shuttle on the burner.
Are you trying to change from natural to LP?
Please let me know if I can assist you further.

Thanks
Vic