I need a wiring diagram for a sentrek 3800 equalizer that goes in a car

notify sentrek or online for manual

http://www.greatautohelp.com/sensor-location/3800.html

http://www.autozone.com/repairinfo/repairguide/repairGuideContent.jsp?pageId=0996b43f80cb3c4c

the top one shows locations ,and the bottom link is wiring diagrams...Hope this helps...

Possible bad sending unit or shorted sending unit wiring.

Make sure its the correct fuse as far as the amp rating goes. If thats fine, use a wire diagram to trace the wires for short circuits.

I need to see a diagram how or how to setup my equalizer and reverb to my amp all pioneers old stuff sg60 and sg540

i dont recommend u use if u dont know

that wire is for ignition or accessory power source

The remote turn-on wire for an amplifier connects to a switched power source. If the head unit has a power antenna lead, or amp control lead, use it. If not, the remote lead can go to a power source that is switched with the ignition key. No matter the source, you need to fuse the wire with a 1 amp fuse at the point where you connect to the power source.

That company went out of business some years ago, so it's difficult to find the specs or pictures of it to be super accurate, but generally speaking it should have a "Battery", "Remote", and "Ground" set of terminals and a pair of spaker terminals each with a positive and negative. The battery terminal goes to the battery, the remote terminal goes to the remote output lead (usually blue/white) on the head unit, and the ground terminal goes to the chassis of the car. The speaker terminals go to the speakers (observe positive and negatives).