I want to remove the wattage limitor from my ceiling fan/light.

The gray tan and the other wires usually have plug on the end and the plug into the fan unit when it's put together . The part the mounts to the ceiling should be blue black and white

There are no wiring diagrams for most travel trailers. Check all of your 12 volt fuses. If none are blown, pull each light fixture one at a time and look for loose/bad connections. You'll need to remove each fixture from the ceiling to get to the wiring behind it to check. Normally the lights will be run parallel meaning if you have a bad connection at one, the rest down the line will not work.

It is probably in the switch wiring. the switch is probably the issue as it is probably 3 way. Check the switch if no problem then the motor is probably shot.

1999 Toyota Corolla Car Radio Stereo Audio Wiring Diagram
Car Radio Constant 12v+ Wire: Blue/Yellow
Car Radio Switched 12v+ Wire: Gray
Car Radio Ground Wire: Brown
Car Radio Illumination Wire: Green
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Pink
Left Front Speaker Negative Wire (-): Violet
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Blue
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Black
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Red
Right Rear Speaker Negative Wire (-): White

I believe the lutron will connect at the pull switch. That model # isnt workings for me though. I am finding 85112-02 but not 04. You can try googling 85112-02 remote wiring and there are many results. The hunter remote module may stay in place and the lutron will connect via the pull string wires. maybe. If you can confirm the model and maybe the lutron model I can look more.

Replace the relay.

Go into the boot and access the tail light clusters under their covers in the boot rear corners. Take a lead (you can buy double adapter spade connectors) from (1) a tail light, (2) a brake light, (3) the right indicator, (4) the left indicator. (5) a solid earth wire. Try using different colour wires, making a note of each source and each corresponding colour. Tape them together and lead them to the trailer plug. There is a set international configuration for the trailer plug connections which is shown below.

Pull out signal lights and look for naked wires that may be grounding out if you find one use black tape or cut splice together , solder, and heat srink them back together,If you dont find any check switch that turns lights on. sometimes they get hot and melt and have to be replaced.

These diagrams should be useful in assisting you to wire the trailer connectors properly. A five way connector is like a four way with an extra blue wire for the electric brakes. A test light should be used to be certain that the wires are connected to the trailer connectors properly before you actually connect the trailer connectors together.

check to see if you have it hooked up right. use a wirer tester and see which is the constant wire and which is the battery wire. the constant wirer is always on and the battery wire is on when you turn your key on. and check to see if your ground is properly connected to a ground spot. if you hear or see a spark then there goes your fuse so be carfull on where you put your wires.