Code hitachi lcd hdtv combo

try this link might tell you.
Is my Hitachi L26D205 region free Google Search

You can download the setup guide and user manual from the link below
Insignia 32 inch Class 1080p 60Hz LCD HDTV Blu ray Disc Combo

VCR codes)
TYPE BRAND CODES VCR Canon VCR Sony

You can, but you will have to turn the resolution on the BD down to 1080i since this is the highest your TV will support. Most BD players will ask or determine the resolution during the initial setup of a new player.

If this was helpful, please rate

If the TV works fine with other sources the problem is the HDMI output is not enabled on the BD player.
Most BD players do not output both HDMI and composite formats simultaneously. Check to make sure the HDMI output is selected on the BD player and the TV. This information is in the manuals, read the book.

Cheers

TOSHIBA ... 112 313 413 506 510 512 613 902
UNIVERSAL .............. 310 806

644 works with the Samsung BD-P1590/BD-P1590C/BD-P1600 om my Blue Button Dish Remote for the 722k.

42 " HDTV
using Bigmatters universal jumbo remote (ER04305J 07/07)
Hope you can help.

PROGRAMMING DEVICE CONTROL
The One For All 3 Device Universal Remote Control is preprogrammed at
the factory to operate an RCA TV, a Toshiba DVD player, and a Motorola
cable box.To control devices other than the default brands,perform the following
steps; otherwise skip this section:
1. Turn on a desired device (e.g.,VCR or DVD player) and, if
applicable, insert media (e.g., cassette or disc).
NOTE: Please read steps 2 through 4 completely before proceeding.
Highlight or write down the codes and device you wish to program
before starting step 2.
2. On the remote control,press a device key once (i.e., DVD/VCR,
CBL/SAT,or TV).
NOTE: To program control of a VCR, PVR (or DVR),TV/VCR Combo,
or TV/VCR/DVD Player Combo press DVD/VCR once.After programming
a VCR Combo device, you will be able to control channel selection,
volume, and VCR functions.
NOTE: To program control of a DVD Player,DVD Player/VCR
Combo, or TV/DVD Player Combo, press DVD/VCR once.After programming
a DVD Combo device, you will be able to control channel
selection, volume, and DVD functions.
NOTE: To program control of a Cable Box, Cable Box/PVR (or DVR)
Combo, Satellite Receiver, or a Satellite Receiver/PVR (or DVR)
Combo, press CBL/SAT once.
3. Press and hold SET until the LED (red light) blinks twice,
then release SET.
4. Use the Manufacturer’s Codes (starting on page 18) to
locate the type of device and brand name and then enter
the first four-digit code for your device. If performed correctly,
the LED will blink twice.
NOTE: If the LED did not blink twice, repeat steps 2 through 4 and enter
the same code again.
5. Aim the remote control at the device and press POWER
once.The device should turn off. If it does not, repeat
steps 2 through 5, trying each code for your brand until
you find one that works. If it still doesn’t work, try
Searching For Your Code on next page.
NOTE: If the device does not have a POWER key, press PLAY.
6. Repeat steps 1 through 5 for each device you want to control.
For future reference,write down each working device

Here is a link to your manual:
http://www.ofausa.com/remote_manual/CTGA...

batteries low,,or button stuck