Can I turn off memory on Casio DR-T220? - Casio Office Equipment & Supplies

To load paper into the Casio DR-T220 thermal printer calculator, follow these steps:

1. Open the printer cover by pressing the release button located at the front of the calculator.
2. Carefully insert the roll of thermal paper into the printer with the paper facing forward, and the end of the paper coming out of the top of the roll.
3. Adjust the paper guide to fit snugly against the paper roll.
4. Close the printer cover.
5. Turn on the calculator and press the "Feed" button to advance the paper to the correct position for printing.

Please Note: Be sure to use the correct type of thermal paper for your calculator, as specified in the user manual.

Go to Casio Support Webpage and download the Owners Manual.

Here: http://www.casio4business.com/sa/support/downloads/downloads_manuals.html

The Casio DR-T220 does not use regular adding machine tape, it requires a thermal tape since it is a thermal printer. There is no ink or ink ribbon in this caculator, it is heat activated and it is the special paper that make the numbers appear. Thermal tape is available at all office supply stores.

Put the roll in and feed the loose end up and actually all you need to do is put it between the two pieces of the hinge top. it is a thermal printer so it does not need to be fed like a regular calculator...it took me a few tries before I figured it out.

Hi,
Try the link below.

http://www.casio.com/support/techsupport/calculators

http://www.servicecasio.com/download/manual/DR-T220.pdf

press the plus key again, it should work. ie put a number in and press the plus key twice, it should double, and again it should double again and so on

Turns out the incorrect type of paper was being used. The paper needed is the paper that is sensitive to pressure and this paper was not.

I have a model DR-T120 maybe it works the same way.
press
CA
TIME
% (hold for about 2 sec)
"enter date and time"
Note( any time during setting procedure you can press = to cycle date format mm-dd-yyy, dd-mm-yyy, yyy-mm-dd)
TIME
Hope this Helps.
Rick

Try resetting the calculator. There should be a reset button on the underside of the machine. Press it with a pen and that should clear the E that is on your display.