I have an Igloo ICE206-TG-Silver that goes through the entire cycle (compressor works, fan works, fills with water) but there is no ice being made. I tried to reset to no avail.

Mike Johnson

• 291 Answers

SOURCE: GE SIDE X SIDE Dispenser problem

Sound like maybe a dispenser board short... you could try taking of the top hidge cap on the freezer side unplug the power to the board there for 30 minustes or so plug back in and see if it can reset to default and try that before u have to change board

Posted on Aug 21, 2007

SOURCE: RS2556SH Side by Side - Icemaker not filling; fill tube not iced over!?

press the reset button (black) on the bottom of the icemaker, the system will go through a cycle, and water will pour into the tray.

Posted on Oct 26, 2007

SOURCE: Samsung side by side RS2556BB. Ice maker is not dumping ice out.

you need to remplace your control board
is not suppling power to the ice maker heater element you will find the control boar nex to the wather valve

Posted on Jun 07, 2009

SOURCE: Whirlpool Refrigerator Model ED25PW Ice maker tray not filling with water

Just had this issue - after checking all line connections, I pulled the ice maker feed water line from the back of the unit and found the tube was blocked with ice. Melted the ice with some hot water, and all is good once more. I would check for this before getting into the solinoid.

Posted on Jan 25, 2010

SOURCE: My icemaker fills the tray but when the water

My ice maker would not return to a level position after dumping out the ice. When the water turned on to refill the ice tray, it would run off the tilted ice tray and into the ice basket thus freezing all the ice cubes in the basket together. To remove the icemaker, there are two screws that hold the icemaker to the top of the freezer. Turn off the icemaker. Remove the left screw and loosen the right screw by removing the screw on the left. Slide the icemaker outward and it should come loose. Unplug the power connector from the icemaker to the freezer. The ice tray can be removed from the icemaker by gently pulling the tray to the right and the slot it goes into on the left side of the icemaker to the left. Once the tray is out of the assembly, inspect the round plastic shaft on the left side of the ice tray. Mine had two flat spots that were worn into the plastic from use. I used a dremel tool with a round barrel sanding disk at the tools lowest speed to remove the flat spots and decrease the overall diameter of the shaft which stopped the tray from sticking. Reassemble the ice tray in the icemaker.

Posted on May 28, 2010