Cover my printer keeps saying door open after i replaced ink cartiage also will not turn off

Remove the ink cartiage and also the print head and reset the printer and then have the ink cartiage and the pinhead being reinserted again. Or the pinhead needs to be replaced and the ink cartiage also needs to be replaced and look for any paper being stuck inside of your printer too and remove any paper jams.

return it to the store. for a new one. if that doesn't fix then contact brother if it is still under warranty.

Solution 1. you need to remove and return tightly the ink cartridge.

Solution 2. maybe you purchase ink cartridge that are not compatible with the printer.

Solution 3. if you are only refilling the ink cartridge, maybe it is worn out and the printer is no longer detecting the cartridge due to wear and tear.

To reattach the cartridge check the following steps :

turn on the lid of the printer and then remove the cartridge from the printer head.

Check the cartridge to make sure that there are no scratches or other damaged parts that can contribute to a printer cartridge error report.

Take note that the cartridge should not be left open for more than 30 minutes; otherwise the ink will start to dry up and the cartridge will get clogged.

Why are you taking out the ink cartridges??
The message says to open the carriage access door and clear the jam. The printer thinks that paper is stuck in the paper path, see if you can find it. I believe that there is also a rear door on that printer, remove it and look inside.

Perhaps the Lexmark X6100 Series User's Guide will be able to help you. Just click on this link: http://bit.ly/9OkJ8G. Scroll to Maintaining your All-in-One, Page 76, for instructions on how to replace the print cartridges.

In some cases, the ink cartridge carrier won't position itself in the middle even when the printer is on and the cover is open. Just unplug the printer from the power source. With the cover open, hold the white tape in the middle inside the printer. The other end of it is connected to the carrier. Gently slide the carrier to the center. Load the cartridges. Close the cover. Plug the printer back to power source. Hope this helps.

Power on the printer ,
Open the right most corner cover when facing to printer ,Cartiage container will rest to stable position ,hold cartiage from top and twist it towards your direction ,it ill come out

ink cartiage not properly installed ae shown but my cartiage are riffil

Go to menu to reset drum settings. I think you leave the front cover open press the right arrow then 1 one the lcd shows replace drum then after the lcd says accepted close the front cover.

i have an hp office jet 5510 and its not print and it keep on saying cartiage is jam , the timeing is all mess up the leg that bring the paper out keep on coming up whilethe cartiage is going across is there a way of reset the print to get back the timeing