Just replaced motor on pellet stove

The cable connection between the key assembly and the ignition switch may have come loose at one end, or the switch is not installed at the correct spacing down the column, or the switch has come loose from the mounting bracket on the column.

Do you have a user's manual? Most pellet stoves need to be lit before starting the auger to sustain the fire.

Wood burning or pellet stoves create acid vapor. The vapor damages thermocouples faster than a gas stove.

Buck Stove ' Hearth.com Forums Home

www.hearth.com/talk/threads/buck-stove.45094/
Jan 6, 2010 - I replaced the blower motor. immediately blower would run for... ... Buck Stove 26000 insert (1982, in the living room fireplace) Has kept ... I throught the same thing so I fired the stove really hot, motor would not run past low setting and ..... I have a pre-1979 Regular Buck 27000 where the thermal disks are ... Anyone burn an insert without the surround?
Jan 8, 2012
Insert Blowers - to use or not?
Jan 3, 2011
Buck Stove Fan Noise
Dec 27, 2010
Any HVAC Techs or Electric Motor Gurus Here?
Nov 22, 2010
More results from www.hearth.com

Warnock Hersey is not actually a manufacturer's brand, but a certification. You can find more info here: http://www.wood-stove.org/firebelly-stoves.html .
or you could try this link:


http://www.pelletking.com/pellet-stove-manuals/Whitfield-Advantage-IIT-Pellet-Stove-Manual.pdf


I hope this helps you out & if it does please don't forget to rate me, kind regards, Paul

1 fan is for cooling the motor and the other fan comes on when the ac is turned on or its very warm outside it 2 stage

Check your blower motor resistor connection.Turn switch and fan on then wiggle the resistor pigtail fan should turn on if not replace resistor.These get to hot and usally melt the pigtail and loose their connection.

Check your coolant levels and make sure the hose between the coolant reservoir and the radiator aren't clogged. The cooling fan on the radiator may not be directly driven by the serpentine belt and may be on a clutch. If the clutch is broken the fan won't cool the radiator and the radiator won't cool the car. Get the car good and hot and see if the fan kicks on. To temporarily relieve the overheating in the engine, turn the heat on in your car.

fan motor will not shut off