Question about Kenmore Coffee Makers & Espresso Machines
I can pull top cup off, there is nothing there ?
SOURCE: Fabric softener doesn't dispense
Fabric softener dispensers are notorious for getting all gummed up and clogged. Remove the dispenser cup and soak in some hot water to dissolve all residue. While you have the dispenser removed check under the dispenser cap in the agitator for gummy residue as well. Clean with hot water. There should also be an agitator seal cap under the dispenser. Make sure the cap and rubber o-ring are seated properly. Last of all, if the dispenser has a cone shaped cup inside, make sure it is inserted cone-side UP. The cup is designed to allow fabric softener to roll down the sides of it, NOT hold it. I hope this helps.
Posted on Apr 29, 2007
There is a 1/4" machine screw in a recessed hole close to the bottom of the agitator. Remove screw. Lift agitator off agitate shaft.
Posted on Nov 28, 2007
SOURCE: gunk in middle of agitator
the fabric softener spins out of the cup after the wash cycle when spinning the water out of clothes, then the washer fills back up for the rinse w/ your softener having been dispensed. is there a nut at the bottom of your agitator where you see the gunk? If so you can take the agitator out by removing the nut but be careful of the little parts that make the agitator agitate. Do not disturb these little parts if you don't know about them. Does the gunk smell like grease or a mechanics garage? If so chances are it is a lubricant and should not be removed replace the cap and your softener cup and continue enjoying your machine.
Posted on Jan 08, 2009
Hi. your problem is actually a rather complicated one.
Timer and selector switches The timer switch is usually the largest dial on the main control panel. It can be either a mechanical device much like a simple clock, or completely electronic with just a digital readout.
The timer runs the washing machine in a pre-determined pattern. It provides the electricity to all of the washing machine components at the correct time and for the correct length of time.
The Start switch is usually part of the timer knob. When you set the timer to the proper cycle, you either pull or push the timer knob to start the cycle.
The selector switches or knobs vary from machine to machine. Most washing machines have one or several switches or knobs on the control panel besides the Timer/Start switch. These let you adjust certain settings; for example, the water temperature, spin speed, timer cycle, and so on. Normally, the washing machine completes the cycle selected on the timer, regardless of how you set these switches and knobs.
Posted on Jul 14, 2009
Yes it is,although the whole peice running half way down will probably have to be purchased..It's called the(Clothes Mover)it has finns running down & can be removed by a bolt down the centre after removing the top cap.
Posted on Jun 03, 2010
Tips for a great answer:
Feb 05, 2013 | Washing Machines
Jun 21, 2011 | Washing Machines
Dec 01, 2010 | Maytag Washing Machines
May 21, 2010 | Whirlpool LSR5132PQ Top Load Washer
Nov 10, 2009 | Bosch Washing Machines
Oct 12, 2009 | Frigidaire Washing Machines
Sep 07, 2009 | KitchenAid KAWS850L Top Load Washer
Aug 27, 2009 | Kenmore 24902 Top Load Washer
Jan 05, 2009 | Kenmore 98702 Stacked Washer/Dryer
Apr 09, 2007 | Kenmore 24982 Top Load Washer
Dec 28, 2014 | Kenmore Coffee Makers & Espresso Machines
56 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: