GTRom loader to get bin files for pansat 2700a

try code 0156. If that doesn't work, try searching for the code using the remote. Direcections should be in the manual for the remote.

press "MENU" on remote, then press button directly below the "OK" button on remote 3 times to highlight "USER SETUP", then press the "OK" button on remote, then press the button directly under "OK" button 2 times on remote to highlight "TV TYPE" , then press left or right button directly beside "OK" button on remote to change it to "NTSC" .

Short version:

• "MENU"
• "USER SETUP"
• "TV TYPE" , Change to "NTSC"

Make sure both the TV and the unit are set to either NTSC or PAL. Sometimes this will happen if one or the other is set different.

You can easily download the manual as pdf. from their website
http://www.pansat.com

001, 006, 021, 050, 089, 101, 105, 127, 133, 160. You can probably download your manual from PANSAT's website under Technical Support.

Press TV/Rad button to restore TV channels.

If you loaded a new program, make sure you check your DiSeqc switch settings if you are using one. Also make sure your dish is align properly. Try to do a blind scan to see if you pick up anything that is available from the satellite.
If nothing works, I would suggest to check C13 and C14 for bulging conditions, if they are defective; you will need to change them.
Good Luck.

John, The resolution to your problem can be found at ftatalk.com. Go there and read all about your receiver and if you have any specific questions please post again and I will answer them.

that bin file is burnt. hard reboot...

tengo pansat 2700a cada ves cambio el bin nesecito scañar los canales de nuevo.que hago ????