Manual for Casio Label It N78 - Casio Office Equipment & Supplies

google for manuals took less than 5 seconds.
manual for a CASIO KL 400 label printer

Here are some steps you can try to clear the problem:

1. Check the Label Tape: Ensure that the label tape is properly installed and correctly aligned in the label printer. Sometimes, an improperly installed label tape can trigger an error message.
2. Check for Paper Jams: Open the label printer and check for any paper jams or obstructions that might be causing the error. Clear any jams or obstructions you find.
3. Replace the Batteries or Use AC Power: If your Casio KL-60 label printer is powered by batteries, try replacing the batteries with fresh ones. If you're using AC power, make sure the power adapter is working correctly and properly connected.
4. Perform a Soft Reset: Turn off the label printer and unplug it from the power source (if applicable). Wait for a few seconds, then plug it back in and power it on again. This can sometimes resolve temporary issues.
5. Check the User Manual: Consult the user manual or troubleshooting guide that came with your Casio KL-60 label printer. It may have specific instructions for troubleshooting error messages.
6. Factory Reset: If the error persists and you have tried all other steps, you may need to perform a factory reset to restore the printer to its default settings. Keep in mind that a factory reset will erase any custom settings you may have made.

try this site

https://www.manualslib.com/products/Casio-Kl780l-Ez-Label-Printer-2544.html

Hi,Download link:http://support.casio.com/pdf/005/KL_60_E.pdf

http://support.casio.com/manualfile.php?rgn=1&cid=005003010

http://support.casio.com/manualfile.php?rgn=1&cid=005003001

Go to casio.com and download the manual for the KL-7000 label printer. The instructions are essentially the same as for the KL-1500 allowing for physical differences.

http://world.casio.com/ds/download/en/manual/

You can download Casio Label Printer manuals from our Blogs support centre, here is the link..
http://blog.labelzone.co.uk/support-centre/casio/

Hope this helps.

Regards

LabelZone

to reset memory
1. Make sure that label printer is off
2. While holding down the PRINT and ESC keys, press ON?OFF to power on.
3. KEEPING PRINT and ESC held down, release the ON?OFF key only.
4. Release PRINT and ESC keys.
5. Press SET to initialize the Label Printer or ESC to Abort

http://ftp.casio.co.jp/pub/world_manual/ds/en/KL_60_E.pdf