Question about Precor C954i Commercial Treadmill
IFT Drive Issue
Posted on Mar 03, 2019
SOURCE: Error 30 shows when i
Any 30 series error code means that their is no communication between upper and lower boards.
The main Telco harness ( looks like a telephone or DSL wire) my have a bad or broken connection. Unplug unit and taken motor shroud off and check connections should be able to plug and unplug same goes with upper console. If this does not help then either call a local service provider or call Precor directly give them the Model# and Serial# for this unit. They should provide you with the additional info needed
Posted on May 09, 2011
If the console takes batteries, replace them. If this does not work or your console does not require batteries, check the reed switch or optic sensor. Reed Switch: Unplug the treadmill and remove the motor hood cover. The reed switch is mounted on the frame next to the front roller pulley. There is a magnet glued into the front roller pulley. When adjusting the reed switch, make sure it is pointing directly at the magnet. Move the tip of the reed switch within 1/8" of the magnet. Also, check to see that the wire is not damaged, and is connected to the console.
Optic Sensor: Unplug the treadmill and remove the motor hood cover. The optic disk and sensor are located either at the end of the motor or the right hand side of the front roller. The optic disk spins between two sensors on the optic switch. The disk must spin freely without touching either sensor. The sensors can be moved by loosening the adjustment bolt holding the switch to its bracket. The switch can then be slid. Center the disk.
Remember :The controller for console or display have circuit for magnetic swithc.
Posted on Nov 21, 2011
Please adjust the speed sensor see the diagram attached.
After RUN the software calibration for easy diagnostic and troubleshooting
See my personal TIPS FOR Help.
sincerely. God bless you
Posted on Mar 31, 2012
1) adjust the reed swithc, clean , and tigh the wire connectors very well
2) run the software calibration for diagnostic and troubleshooting.
God bless you
Posted on Jun 20, 2012
Tips for a great answer:
Nov 13, 2015 | Precor Exercise & Fitness
Jul 16, 2014 | Precor C954i Commercial Treadmill
Jun 30, 2014 | Precor Exercise & Fitness
Sep 08, 2012 | Precor C954i Commercial Treadmill
Mar 30, 2012 | Precor C954i Commercial Treadmill
May 04, 2011 | Precor C954i Commercial Treadmill
Apr 06, 2011 | Precor C954i Commercial Treadmill
Jun 30, 2010 | Precor C954i Experience Treadmill
Feb 27, 2010 | Precor C954i Commercial Treadmill
1,214 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: