My zero turn won't move forwRd or backward - Garden

https://poweredoutdoors.com/zero-turn-mower-wont-move-or-go-forward/#:~:text=A%20zero%20turn%20mower%20may%20not%20move%20or,can%20cause%20the%20zero%20turn%20to%20not%20move.

This might help.

ask JUKI yet?

usually if the pins are pulled out that is the freewheel position. push them in to drive. if the trans locks in drive and it is hard to push it should be ready to mow. unless the drive belt is stretched or broken or a linkage is out of adjustment or broken.

I had a similar problem with my TroyBilt 50 inch zero turn mower. Was cutting grass when it stopped going either forward or backward even though it would start and the PTO would move the cutting blades. Turned out the tensioner spring for the belt that drives the motors near the rear wheels had gone missing. Searched the yard where I had cut and moved the machine but couldn't find it. A new one cost me about $7.50. Put the new one on and it worked fine.

Get another switch from a junk yard. the seat will not move manually. If you're going to try to jump the switch it's easier to just replace it.

tighten or replace drive belt

did the belt break or fall off? are the trans release levers pulled out ?the ones you release to push it around

This page says there's one solution. What is it? Where is ti?

Check the pump.Thanks for asking and I hope this helps out.Please leave me 4 thumbs up.

Do you have a bad axle shaft? It can turn the inner axle inside the joint and not move the car as if the trans is bad.