2001 lumina turns on-- but doesn't turn over

Fix your car right away by clicking the link I attached 2001 Jeep Wrangler

Hello:Try this procedure: turn key on, turn to start, let key come back to on wait ten minutes, turn key off wait 10 seconds turn key back on wait 10 minutes. turn key off wait 10 seconds turn key back on wait 10 minutes turn key off wait 10 seconds NOW try and start. In addition you might try tapping on switch assembly while trying to start. There is not any way to disable passlock. You might try having the engine control system codes read

Anti theft is activated, try locking the doors with the power lock transmitter and manually unlock the driver door with key to see if security light goes out.Hope this helps

Hello: Try this procedure, Turn key on attempt to start engine leave key on, the security light should be blinking, wait 10 minutes. The security light should be off. Turn key off for 10 seconds, turn key back on (DO NOT ATTEMPT TO START) wait another 10 minutes. Turn key off for 10 seconds. Do the procedure again as in step 2. At the end of the third time turn key off then ten seconds later attempt to start the car. It should start.

IF BATTERY CABLES CLEAN AND TIGHT.STARTER AND SOLENOID GOOD.SEE IF YOU SEE THEFT LIGHT ON WHILE KEY IN RUN POSITION.IF SECURITY LIGHT ON YOUR CAR IS IN THEFT SECURITY MODE.TRY ANOTHER KEY.PUT IN IGNITION FOR 10 MINUTES IN RUN POSITION WITH ENGINE OFF.WHEN SECURITY LIGHT TURN OFF. TURN OFF IGNITION SWITCH .WAIT 5 SECONDS TRY CRANKING TRUCK.IF STILL DONT CRANK.HAVE TRUCK HOOK UP TO A SCANNER TO CHECK FOR THEFT SECURITY MODE FAULT.

It doesn't have to be the security. a dead battery won't let the car crank either. With a security problem the car will crank but not start. The security can be reset if the battery is charged and up. Turn the key on ( do'nt crank ) the security light will stay on if it needs to be reset. If it remains on leave the key on for 15 minutes around then it will go out. turn the key off and then turn it right back on, the security light will be on again. Leave the key on till the light goes out again, then turn it off then turn it back on , wait again when it goes out turnthe key off then right back on then crank the engine and it should start. With a scanner the code will be security neweds to be reset. Thia is all anyone can do to reset the security and it's what you were charged $450 for. Following directions.

Could be several things....but i need more information. When it doesnt start, does it crank or when u turn the nothing at happens other than the relay?

After you replace the ignition switch turn the key to start the car and release leave the key were it stops after trying to start wait 10 minutes until security light goes out turn key to full off position then repeat the above procedure two more times for a total of three on the 3rd attempt to start car wait for light to go out then turn key to full off positoion wait 10 seconds then try to start car body control module should learn new pass code and the car should start.
Big john, J@J Automotive

does it have a coded key?

Is your security light flashing ?if so you have a problem with the anti theft system.Leave the key on for 10 minutes ,then try this should reset the anti theft system